ADIC Version 5.0 manual Configure Printers, On Solaris

Installing VolServ

#

#Intermec Printer:

barcodelabel:\

:lp=/dev/ttyb:sd=/var/spool/lpd:\

:br#9600:ms=evenp:

	Step 2.	If these printers are not attached to the VolServ host
		machine serial ports A and/or B or if they are
		attached to parallel ports or a remote machine, the
		system administrator must set up the
		/etc/printcap file to define the printers.
	Step 3.	To simplify the printcap file modification, use the
		names of the label printers as defined in the
		label_printers.config file. Otherwise,
		different names used in the printcap file must also
		be defined in the label_printers.config file.
	Step 4.	Cycle VolServ to pick up the changes.
		# volserv -t
		…
		# volserv
	Step 5.
		Cycle vswin (if open) to pick up the changes.
Configure Printers	Solaris only: The system administrator must use the Solaris
on Solaris	admintool utility to configure the label printers.

This procedure is written for an Intermec barcode label printer attached to a Solaris server. A similar procedure can be applied to the installation of the Seiko shelf label printer.

3-18 Post Installation Tasks 601351 Rev A