Black Box kv1161a, kv1081a manual To connect the Global user IP network port, IP network link

Global user (IP network port)

The ServSwitch CX Uno IP models provide an autosensing Ethernet IP port that can operate at 10 or 100Mbps, according to the network speed. The ServSwitch CX Uno IP models are designed to reside quite easily at any part of your network:

•They can be placed within the local network, behind any firewall/router connections to the Internet, or

LOCAL GLOBAL

USER USER

IP

SAM

COMPUTER POWER

SYSTEM SWITCH

To connect the Global user (IP network) port

1Depending upon where in the network the ServSwitch CX Uno IP is being connected, run a category 5, 5e or 6 link cable from the appropriate hub or router to the ServSwitch CX Uno IP unit.

2Connect the plug of the link cable into the IP port on the front panel of the ServSwitch CX Uno IP unit.

ServSwitch CX Uno IP

front panel

®



•They can be placed externally to the local

network, on a separate sub-network or with an open Internet connection.

Wherever in the network an ServSwitch CX Uno IP is situated, you will need to determine certain configuration issues such as address allocation and/or firewall adjustment to allow correct operation. Please refer to Networking issues within the Configuration chapter for more details.

IMPORTANT: When an ServSwitch CX Uno IP is accessible from the public Internet or dial up connection, you must ensure that sufficient security measures are employed.

BLACKBOX

CX UnoIP

IP network link

3Configure the network settings as appropriate to the position of the ServSwitch CX Uno IP within the network - see Networking issues for

details.

  

