Lathem 2121 manual Test that Clock Is Now Set Correctly, Close and Lock the Unit

Page 11

Model 2121 Time Recorder User’s Guide

8.Test that Clock Is Now Set Correctly

8.1When the clock advances to the next minute, you hear a distinct click.

8.2Insert a card or piece of paper below the print ribbon.

8.3Push lever on front of the unit down to make a print.

8.4Verify that the clock face time matches the printed time. If it does not, start again with Lift the Type Section. Otherwise, continue to step 9.

9 Close and Lock the Unit

9.1Slide the case cover on the unit.

9.2Turn the key to lock the unit and remove the key.

Note: This completes the setup of this unit. The following procedures contain service instructions.

Page 9

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Model User’s Guide Contents Http//shop.lathem.com Ordering AccessoriesUnlock and Remove the Cover Mount Clock in Suitable LocationLift the Type Section Set the Printed Day and Time Day Wheel Set Hands on Clock Face Lower the Type Section into Place Advance Print Wheels and HandsPage Close and Lock the Unit Test that Clock Is Now Set CorrectlyChange the Ribbon Change the Type Section Change the Motor Trouble Shooting One-Year Limited Warranty Warranty
Top Page Image Contents