Samsung 500 manual ESC a n, ESC c 3 n, Justification

Chapter 5

Control commands list

ESC a n

[Name]	Select justification
[Format]	ASCII	ESC	a	n
	Hex	1B	61	n
	Decimal	27	97	n
[Range]	0 ≤ n ≤ 2, 48 ≤ n ≤ 50
[Description]	Aligns all the data in one line to the specified position.

n selects the type of justification as follows:

nJustification

0, 48 Left justification

1, 49	Centering
2, 50	Right justification

[Notes]

The command is enabled only when input at the beginning of the line.

A portion of data skipped by means of HT is also target data for the justification function.

[Default] n = 0

[Example]

ESC c 3 n

[Name]	Select paper detector(s)to output paper end signals
[Format]	ASCII	ESC	c	3	n
	Hex	1B	63	33	n
	Decimal 27		99	51	n
[Range]	0 ≤ n ≤ 255
[Description]	Selects paper detector(s) to output paper end signals, using n as follows:
Bit	Off/On	Hex	Decimal		Function
0	Off	00		0	Paper roll near end sensor disabled.
	On	01		1	Paper roll near end sensor enabled.
1	Off	00		0	Paper roll near end sensor disabled.
	On	02		2	Paper roll near end sensor enabled.
2	Off	00		0	Paper roll end detector disabled.
	On	04		4	Paper roll end detector enabled.
3	Off	00		0	Paper roll end detector disabled.
	On	08		8	Paper roll end detector enable.
4	-	-		-	Undefined
5	-	-		-	Undefined
6	-	-		-	Undefined
7	-	-		-	Undefined

[Notes]

Left justification

ABC

ABCD

ABCDE

Centering

ABC

ABCD

ABCDE

Right justification

ABCC

ABCDC

ABCDEC

It is possible to select multiple detectors to output signals. Then, if any of the detectors detects a paper end, the paper end signal is output.

Detectors are switched when executing this command.

Because of this, the paper-out signal switching may delay depending on the receive buffer state.

[Default] n = 15

51 52