Samsung 500 manual ESC G n, ESC J n, ESC R n, ESC U n, Character set

Chapter 5

Control commands list

ESC G n

[Name]	Turn double-strike mode on/off
[Format]	ASCII	ESC	G	n
	Hex	1B	47	n
	Decimal	27	71	n

[Range]	0 ≤ n ≤ 255
[Description]	Turns double-strike mode on or off.
	When the LSB of n is 0, double-strike mode is turned off.
	When the LSB of n is 1, double-strike mode is turned on.
[Notes]	* Printing is slower in double-strike mode.
	Only the lowest bit of n is enabled.
	The printer does not double-strike for bit-images.
	Printer output is the same in double-strike and in emphasized (ESC E).
[Default]	n = 0
[Reference]	ESC E

ESC J n

[Name]	Print and feed paper
[Format]	ASCII	ESC	J	n
	Hex	1B	4A	n
	Decimal	27	74	n
[Description]	Prints the data in the print buffer and feeds the paper
	[ n x 0.122mm {1/192 inches}] .

[Notes]

After printing is completed, this command sets the print starting position to the beginning of the line.

This command has no effect on the line feed amount set by the "ESC 2" command or the "ESC 3" command.

ESC R n

[Name]	Select an international character set
[Format]	ASCII	ESC	R	n
	Hex	1B	52	n
	Decimal	27	82	n
[Range]	0 ≤ n ≤ 10
[Description]	Selects an international character set n from the following table:
	n			Character set
	0		U.S.A
	1		France
	2		Germany
	3		U.K.
	4		Denmark I
	5		Sweden
	6		Italy
	7		Spain I
	8		---
	9		Norway
	10		Denmark II
[Default]	n = 0

ESC U n

[Name]	Turn unidirectional printing mode on/off
[Format]	ASCII	ESC	U	n
	Hex	1B	55	n
	Decimal	27	85	n
[Range]	0 ≤ n ≤ 255
[Description]	Turns unidirectional printing mode on or off

When the LSB of n is 1, turn on unidirectional printing mode.

[Notes]

Only the lowest bit of n is enabled.

To avoid horizontal printing misalignment, unidirectional printing mode should be used.

[Default] n = 0

49 50