Samsung 500 manual ESC c 4 n, ESC c 5 n, ESC d n

Chapter 5

Control commands list

ESC c 4 n

[Name]	Select paper sensor(s)to stop printing
[Format]	ASCll	ESC	c	4	n
	Hex	18	63	34	n
	Decimal	27	99	52	n
[Range]	0 ≤ n ≤ 255
[Description]	Selects the paper sensor(s) used to stop printing when a paper-end
	is detected, using n as follows :
Bit	Off/On	Hex	Decimal		Function
0	Off	00		0	Paper roll near end sensor disabled.
	On	01		1	Paper roll near end sensor enabled.
1	Off	00		0	Paper roll near end sensor disabled.
	On	02		2	Paper roll near end sensor enabled.
2	-	-		-	Undefined
3	-	-		-	Undefined
4	-	-		-	Undefined
5	-	-		-	Undefined
6	-	-		-	Undefined
7	-	-		-	Undefined
[Notes]
	The printer goes off-line after printing stops.
	The paper roll near-end sensor is an option, therefore,
	if the paper roll near-end sensor is enabled by this command when the
	sensor is not equipped, it does not stop printing.
	The paper roll near-end sensor is enabled when either bit 0 or 1 is 1.
	The paper roll end sensor is a sensor which is always used to
	make an effective to stop printing.
[Default]	n = 0

ESC c 5 n

[Name]	Enable/disable panel buttons
[Format]	ASCII	ESC	c	5	n
	Hex	1B	63	35	n
	Decimal	27	99	53	n
[Range]	0 ≤ n ≤ 255
[Description]	Enables or disables the panel buttons.

When the LSB of n is 0, the panel buttons are enabled.

When the LSB of n is 1, the panel buttons are disabled.

[Notes]

Only the least significant bit of "n" is valid.

When the panel buttons are disabled, no buttons on the panel are usable. If "disabled" is set, the paper feed switch no longer functions.

[Default] n = 0

ESC d n

[Name]	Print and feed n lines
[Format]	ASCII	ESC	d	n
	Hex	1B	64	n
	Decimal	27	100	n
[Range]	0 ≤ n ≤ 255
[Description]	Prints the data in the print buffer and feeds n lines.

[Notes]

This command sets the print starting position to the beginning of the line.

The amount of paper fed per line is based on the value set using the line spacing command (ESC 2 or ESC 3)

[Reference]

53 54