Samsung SRP275APG user manual Memory Switch Bit Function, Contextual Auto-cut Function

- Memory Switch 1

Bit		Function			0		1
F		Reserved
E~5
4		Zero style			Normal		Slash zero
3~0	International Characters (*1)				Refer to the		following table
NOTES
(*1) International Characters Default Value Settings
MSW1-3	MSW1-2		MSW1-1	MSW1-0	International Characters
0	0		0	0			U.S.A
0	0		0	1		France
0	0		1	0		Germany
0	0		1	1			U.K.
0	1		0	0		Denmark1
0	1		0	1		Sweden
0	1		1	0			Italy
0	1		1	1		Spain1
1	0		0	0			Japan
1	0		0	1		Norway
1	0		1	0		Denmark2

- Memory Switch 2

Bit		Function		0	1
F	Reserved
E	How to recover to print ready after inserting paper			Press FEED.	Auto-recovery
D~C	Reserved
B	Printing region width (*1)			Refer to the	following table
A	Paper width selection (*1)			Refer to the following table
9~4
3	Contextual auto-cut function (*2)			Disabled	Enabled
2
1~0	Near end switch function (*3)			Refer to the	following table
NOTES
(*1) Print Region Width (MSW 2-B)/Paper Width (MSW 2-A) Selection
MSW 2-B	MSW 2-A	Printing Region Width	Paper Width
0	0	400 half dots	76mm
0	1	300 half dots	57.5mm
1	0	385 half dots	76mm
1	1	297 half dots	57.5mm

(*2) Contextual Auto-cut Function

This function auto-cuts paper when a paper feed command that feeds continuously over 7/6 inch. Hosts that cannot send an escape sequence, such as <ESC> “d” 0 can cut paper if a 1/6 inch line feed code <LF> is sent seven times.

(*3) Near end switch Function

When an near end switch is mounted, settings should abide by those shown in the table below.

MSW 2-1	MSW 2-0	Near end switch Function
0	0	Disabled
0	1	Disabled
1	0	Reflects the near end switch state to the status.
		Printing does not stop for near end, and the printer does not go offline.
1	1	Reflects the near end switch state to the status.
		Printing does stop for near end, and the printer goes offline.

3-12