Parallel Interface (IEEE-1284)
Pin | Source | Compatibility | Nibble Mode | Byte Mode |
No. |
| Mode |
|
|
1 | Host | nStrobe | HostClk | HostClk |
2 | Host / Printer | Data 0 (LSB) | - | Data 0 (LSB) |
3 | Host / Printer | Data 1 | - | Data 1 |
4 | Host / Printer | Data 2 | - | Data 2 |
5 | Host / Printer | Data 3 | - | Data 3 |
6 | Host / Printer | Data 4 | - | Data 4 |
7 | Host / Printer | Data 5 | - | Data 5 |
8 | Host / Printer | Data 6 | - | Data 6 |
9 | Host / Printer | Data 7 (MSB) | - | Data 7 (MSB) |
10 | Printer | nAck | PtrClk | PtrClk |
11 | Printer | Busy | PtrBusy /Data3,7 | PtrBusy |
12 | Printer | Perror | AckDataReq/Data2,6 | AckDataReq |
13 | Printer | Select | Xflag /Data1,5 | Xflag |
14 | Host | nAutoFd | HostBusy | HostBusy |
15 |
| NC | NC | NC |
16 |
| GND | GND | GND |
17 |
| FG | FG | FG |
18 | Printer | |||
19~30 |
| GND | GND | GND |
31 | Host | nInit | nInit | nInit |
32 | Printer | nFault | nDataAvail /Data0,4 | nDataAvail |
33 |
| GND | ND | ND |
34 | Printer | DK_Status | ND | ND |
35 | Printer | +5V | ND | ND |
36 | Host | nSelectIn |
USB Interface
Pin No. | Signal Name | Assignment (Color) | Function |
|
|
|
|
Shell | Shield | Drain Wire | Frame Ground |
|
|
|
|
1 | VBUS | Red | Host Power |
|
|
|
|
2 | D- | White | Data |
|
|
|
|
3 | D+ | Green | Data Line(D+) |
|
|
|
|
4 | GND | Black | Signal Ground |
|
|
|
|
Drawer Connector
Pin No. | Signal name | Direction |
| Frame ground |
|
1 | - | |
|
|
|
2 | Drawer kick- out drive signal 1 | Output |
|
|
|
3 | Drawer open/close signal | Input |
|
|
|
4 | +24V | - |
|
|
|
5 | Drawer kick- out drive signal 2 | Output |
|
|
|
6 | Signal ground | - |
|
|
|
C. Notes
Paper dust inside the printer may lower the print quality. In this case clean the printer as follows.
1)Open the printer cover and remove the paper if exists.
2)Clean the print head with a cotton swab moistened with alcohol solvent.
3)Clean the platen roller and paper end sensor with cotton swab moistened with water.
4)Insert a paper roll and close the printer cover.
The remained amount of paper detected by paper near end sensor varies with the diameter of the paper core.
To adjust the remained amount, contact your dealer.
56 | 57 |