Samsung SRP-350 Using the Printer, Control Panel, DIP Switch Set 1 Functions, Button

1-8. Using the Printer

Control Panel

Serial Interface(RS-232C, RS-485) Specification

DIP Switch Set 1 Functions

SW	FUNCTION	ON	OFF	DEFAULT
1	Auto Line Feed	Always	Always	OFF
		Enabled	Disabled
2	Reserved	-	-	OFF
3	Handshaking	XON/OFF	DTR/DSR	OFF
4	Word length	7 bits	8 bits	OFF
5	Parity check	Yes	No	OFF
6	Parity selection	EVEN	ODD	OFF
7	Baud rate selection	Refer to the	Following Table	ON
8				OFF

Baud rate selection

Button

The button can be disabled by the ESC c 5 command.

Press the FEED button once to advance paper one line. You can also hold down the FEED button to feed paper continuously.

Transmission speed

2400 baud

4800 baud

9600 baud

19200 baud

SW – 7	SW – 8
ON	ON
OFF	ON
ON	OFF
OFF	OFF

Panel lights Dip Switch Set 2 Functions

POWER

The POWER light is on whenever the printer is on.

ERROR

This indicates an error.

PAPER OUT

This light indicates the near end of the paper roll. Install a new paper roll and the printer Will continue printing.

When the light blinks, it indicates the self-test printing standby state or macro execution Standby state when the macro execution command is used.

SW	FUNCTION	ON	OFF	DEFAULT
1	Emulation	STAR	EPSON	OFF
2	Reserved	-	-	-
3	Reserved	-	-
4	Reserved	-	-
5	Select Print Density	Refer to the	Following Table	OFF
6				OFF
7	Reserved	-	-	-
8	Reserved	-	-	-

	Print Density
Print Density
		SW - 5	SW – 6
1 ( Light )		ON	ON
2		OFF	OFF
3		ON	OFF
4 ( Dark )		OFF	ON

12 13