Samsung SF-650 manual Radio Frequency Emissions, Russia only, Germany only Fax Branding

Page 12

Radio Frequency Emissions

FCC Information to the User

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

•This device may not cause harmful interference, and

•This device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•Consult the dealer or experienced radio TV technician for help.

Change or modifications not expressly approved by the manufacturer responsible for compliance could void the user's authority to operate the equipment.

Canadian Radio Interference Regulations

This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus as set out in the interference-causing equipment standard entitled “Digital Apparatus”, ICES-003 of the Industry and Science Canada.

Cet appareil numérique respecte les limites de bruits radioélectriques applicables aux appareils numériques de Classe B prescrites dans la norme sur le matériel brouilleur: “Appareils Numériques”, ICES-003 édictée par l’Industrie et Sciences Canada.

Russia only

AE95

Germany only

Fax Branding

The Telephone Consumer Protection Act of 1991 makes it unlawful for any person to use a computer or other electronic device to send any message via a telephone facsimile machine unless such message clearly contains in a margin at the top or bottom of each transmitted page or on the first page of the transmission the following information:

1.the date and time of transmission

2.identification of either business, business entity or individual sending the message; and

3.telephone number of either the sending machine, business, business entity or individual.

Regulatory information_ 11

Page 11 Page 13
Image 12
Page 11 Page 13
Contents Page Copyright CopyrightContentds Using toner saving feature Using power saving featureContentds Resolution Darkness CopyingCleaning the drum Checking display messagesSafety information Important safety symbolsSafety information Operating environmentOperating method Installation / Moving Maintenance / Checking Supply usage Laser Safety Statement Ozone SafetyRegulatory information Regulatory informationRecycling Correct disposal of batteries in this productTaiwan only Radio Frequency Emissions Russia onlyGermany only Fax Branding FCC Information to the UserRinger Equivalence Number Replacing the Fitted Plug for UK OnlyYou should also know that Declaration of Conformity European Countries Important warningApprovals and Certifications EC CertificationChina only About this user’s guide ConventionAbout this user’s guide Conventio Description ExampleQuick Install Guide Finding more informationMaterial Name Description Instructions in the guide to prepare the machineFeatures of your new product Special FeaturesFeatures of your new product Introduction Machine overviewFront view IntroductionRear view Control panel overview Power LED Understanding the Status LEDIntroducing the useful button Turning on the machineBasic setup Setting up the hardwareBasic setup Setting the date and time Changing the clock modeSetting sounds Changing the display languageEntering characters using the number keypad Entering alphanumeric charactersKeypad letters and numbers Correcting numbers or namesUsing the save modes Setting the paperMedia and tray Preparing originalsLoading originals Document feederSelecting print media Guidelines to select the print mediaMedia sizes supported in each mode Mode Size SourceCopy mode Fax modeLoading paper in the tray TraySetting the paper size and type Using the output supportLetterhead/ Preprinted paper SINGLE-SIDED DOUBLE-SIDEDChanging the settings for each copy CopyingBasic copy Changing the default copy settings Setting copy timeoutTo scale the copy by directly entering the scale rate Setting the fax header FaxingPreparing to fax Sending a faxDelaying a fax transmission Sending a fax manuallyConfirming a transmission Automatic redialingAdding documents to a reserved delay fax job Canceling a reserved delay fax jobSending a priority fax Sending a fax in toll save timeReceiving manually in Tel mode Receiving automatically in Answering Machine/Fax modeReceiving faxes manually using an extension telephone Receiving a faxReceiving faxes using Drpd mode Receiving in secure receiving modeActivating secure receiving mode Deactivating secure receiving modeAdjusting the document settings Forwarding a fax to other destinationSetting up address book Using group dial numbers Group dial numbersRegistering a group dial number Editing a group dial numberPrinting sent fax report automatically Machine status and advanced feature Fax setupChanging the fax setup options Available fax setup optionsUsing the advanced fax settings Advanced fax setting optionsCopy setup Changing the copy setup optionsChange Default Printing a reportClear All Mem Menu overview Items OptionMachine status and advanced feature Maintenance Cleaning a machineCleaning the outside Cleaning the insideCleaning the scan unit Maintenance Cleaning the drum Storing the Toner cartridgeHandling instructions Use of non-Samsung and refilled toner cartridgeTips for moving & storing your machine Troubleshooting TroubleshootingRedistributing toner Clearing original document jams Input MisfeedTips for avoiding paper curls Exit MisfeedPressure lever Tips for avoiding paper jams Clearing paper jamsInside the machine Exit areaIf you do not see the jammed paper, go to next step Message Meaning Suggested Solutions Understanding display messagesChecking display messages Power Failure Operation NotAssigned Paper JamSolving other problems Paper feeding problemsPrinting problems Printing quality problemsLight or faded print Toner specksDropouts White SpotsToner smear DefectsBackground scatter MisformedCondition SkewCopying problems Condition Suggested SolutionFax problems Supplies and accessories How to purchaseAvailable maintenance parts Supplies and accessoriesReplacing the toner cartridge PartsSupplies and accessories Specifications Hardware specificationsEnvironmental specifications Electrical specificationsPrint media specifications Type Size DimensionsTRAY1 Contact Samsung worldwide Contact Samsung worldwideCOUNTRY/REGION Customer Care Center WEB Site Luxemburg Glossary Default Dot Matrix PrinterDuplex Duty CycleEthernet EtherTalkFuser Unit GatewayITU-T No chart MAC addressModem NetWareOriginals PostScriptPRN file ProtocolSubnet Mask Toner Cartridge UNC PathWatermark Index Time setting 23 toner cartridge Toner save mode 25 trayTurning on the machine Index
Top Page Image Contents