Mitsubishi Electronics WD-65733, WD-57734, WD-57733 manual Initial NetCommand Setup for Most Devices

Page 49

6. NetCommand

49

Initial NetCommand Setup for Most Devices

To perform this procedure, you need:

The remote controls for both the TV and the device you want to control.

The IR emitter cable supplied with the TV.

Note: To set up an A/V receiver, see “Set Up NetCommand Control of an A/V Receiver” later in this chapter.

1.Connect and position the IR emitters for the devices you wish to control. See “IR Emitter Place- ment” in this chapter.

2.Set the TV’s remote control slide switch to the TV position.

3.Open the NetCommand Learn screen in one of two ways:

If working from the Auto Input Sensing screen for the device, highlight the Learn icon and press ENTER to open the Learn screen for the device.

If performing NetCommand setup at any time after the device has been recognized through Auto Input Sensing:

a.Press INPUT to open the Input Selection menu.

b.Highlight the desired input icon and press ENTER to switch to that input.

c.Press MENU, highlight Inputs, and highlight Learn to open the Learn screen for the device.

4.The first function highlighted in the Learn screen is always Power On. Aim the TV’s remote control at the TV and press ENTER to begin learning for that function.

5.When the Power On text starts flashing, aim the device’s remote control at the TV and press and hold the POWER key until a check mark appears next to Power On.

If the text stops flashing before the check mark appears, repeat this step.

To remove the key from NetCommand control, press the CANCEL key while the key name is highlighted.

6. Press the keys on the TV’s remote control to highlight other keys on the list. Repeat steps

4 and 5 for each additional function you wish to control through NetCommand.

7.If the device’s remote control has keys that are not in the list, you can associate up to any four keys with the F1 through F4 keys.

For example, for a DVD player, assign the F1 and F2 keys to the DVD player’s CHAPTER SKIP FORWARD and

From the Auto Input Sensing screen, highlight the Learn icon and press ENTER to open the NetCommand Learn screen.

Inputs > Learn screen

CHAPTER SKIP BACK keys. Perform NetCommand setup for the F keys the same as you did for the named keys.

8.If the device has a separate POWER OFF key, press on the TV’s remote to highlight Power Off.

Repeat the earlier steps to “learn” the POWER OFF key.

If the device has no POWER OFF key, skip this step.

9.Press EXIT to finish NetCommand “learning” for the current device.

Add or Remove Device Keys from NetCommand Control

1.Press INPUT to open the Input Selection menu and select the affected device.

2.Open the Inputs menu and highlight the Learn icon.

3.When the Learn screen displays:

To add keys: Continue as described earlier under “Initial NetCommand Setup for Most Device Types.”

To delete keys: Highlight the name of the key you wish to delete and press CANCEL on the TV‘s remote control to clear the check mark.

Image 49
Contents WD-Y577, WD-Y657 WD-C657WD-57733, WD-65733, WD-73733 WD-57734, WD-65734, WD-73734For Your Records Refer Servicing to Qualified Service PersonnelContents Lamp Replacement Installation NotesCleaning Recommendations Operating NotesImportant Safeguards Special Features of Your TV Package ContentsControl Panel TV Front PanelFront Inputs Lamp Indicator Front-Panel IndicatorsStatus Indicator Timer IndicatorANT 1/MAIN, ANT 2/AUX Antenna TV Back PanelComponent Inputs Audio and Video Hdmi Inputs IR Emitter NetCommandInput 1, 2 Audio and Video Hdmi Cable CategoriesAdditional TV Setup Guidelines for Setting Up and Using Your New Widescreen TVGetting Started TV OperationInitial TV Setup When You First Power On the TVInstalling the Remote Control Batteries Additional TV Setup Using the Setup Menu Setting Up TV InputsWhen You First Connect a Device Change the Menu LanguageWith a Standard TV Setup Controlling A/V Receiver Sound VolumeMore About Auto Input Sensing This TV accepts digital computer signals only Connecting a Computer to the TVComputer Video Connection Audio Video Output Digital DVIComputer Video Adjustments Using the TV with a Personal ComputerImage Resolution Computer Display FormatsHdtv Cable Box or Satellite Receiver with Component Video Before you Begin18 3. TV Connections VHF Leads Antenna with a Single Lead%1MBZFS DVD Player with Component VideoVideo VCR to an Antenna or Wall Outlet CableVideo LMONO-AUDIO-R Audio Hdmi OUT IR Emitter VCR to a Cable Box Audio & VideoOlder Cable Box Receiver Sound SystemReceivers with Hdmi Inputs Composite Video Connection CamcorderComponent Y Pb Pr Video Connection Hdmi ConnectionChoosing a Viewing Source Sleep TimerTV Tips Blank space Remote ControlChannelView Channel Listings Status Display Signal StrengthAnt TV-PG FAV1ANT-1 FAV Favorite ChannelsSignal Definitions TV Signals and Display FormatsDVD Definitions TV Display Format DefinitionsSee descriptions on the preceding TV Display FormatsJpeg Photos and the USB Photo Port Viewing Jpeg Picture FilesPhotos and Moving Video as Composite Video Media Setup MenuSlide Show Keys for Jpeg Picture Slide ShowMain Menu Remote Control Keys for the TV Menu SystemAV Menu Options AV MenuVideo Menu Options Video MenuAudio Menu Options Audio MenuANT1/ANT2 SAP ANT1/ANT2Captions on Analog Channels Captions MenuCaptions on Digital Channels Captions Menu OptionsSetup Menu Options Setup MenuPhysical Digital Channel Number Virtual Channel Number digital channels onlyEdit ChannelClock SettingsSelect either Applies or Ignore for Daylight Savings Time Timer Timer On, Off DayInputs Menu Options Inputs MenuAVR Lock Menu Setting or Resetting a Pass CodeParent Menu Other Menu Alternate Rating SystemTV-Y Parent Menu Options U.S.-based rating systemTV-Y7 TV-GTime Other Menu Options alternate rating systemFront Panel Important Note on NetCommand About NetCommandTFOTPS *OGSPOUPGB IR Emitter Placement NetCommand0OUPQPGBTJOHMF UBMMEFWJDF TJFEEFWJDFTAdd or Remove Device Keys from NetCommand Control Initial NetCommand Setup for Most DevicesIf the device has no Power OFF key, skip this step Guide PowerCH/PAGE To Control Most Device Types Operating NetCommand-Controlled DevicesSpecial Operation Methods To Control an A/V Receiver Outside the Guide Inside the GuideSetting Up NetCommand Control of an A/V Receiver Before You Begin XJUI EJHJUBMTVSSPVOETPVOE 56 6. NetCommand Appendices Width Depth Lbs Appendix a SpecificationsBypassing the Parental Lock Appendix B Bypassing the Parental LockThis page intentionally left blank Lamp Life Appendix C Lamp-Cartridge Replacement and CleaningTo Order a New Lamp Lamp Part Number 915P061010Lamp-Cartridge Filter Cleaning Lamp-Cartridge ReplacementInstalling the New Lamp Cartridge Removing the Old Lamp CartridgeFunctions Available for Other A/V Devices Appendix D Programming the Remote ControlCode Verification Programming the Remote ControlAudio Lock Universal A/V Receiver Control Audio Amplifiers Brand Code Programming CodesCable Boxes Brand Code CD Players Brand CodeTFC DVD Players/Recorders Brand CodeSatellite Receivers Brand Code Laser Disc Players Brand CodeABS VCRs and DVRs Brand CodeSTS TV Reset Comparison Guide Appendix E TroubleshootingBefore you change sound or picture settings If Reset Name When to Use How to Use Resulting ActionService Service and SupportSupport TV Channels Symptom Remarks General TV Operation Symptom RemarksPicture Symptom Remarks TV Power On/Off Symptom RemarksIndicators Symptom Remarks Symptom RemarksNetCommand Y and 734 series only Symptom Remarks Trademark and License Information Mitsubishi TV Software Mitsubishi DLP Projection Television Limited Warranty Mitsubishi Digital Electronics AMERICA, INC Index Index Page System Reset MDEAservice@mdea.com
Related manuals
Manual 1 pages 1.68 Kb Manual 2 pages 7.78 Kb Manual 2 pages 27.12 Kb

WD-Y657, WD-Y577, WD-73733, WD-57733, WD-65733 specifications

The Mitsubishi Electronics WD-65734 and WD-73734 are part of the renowned line of DLP (Digital Light Processing) televisions that have garnered a strong following among home theater enthusiasts. These models feature advanced technologies that deliver stunning image quality and an immersive viewing experience.

Both the WD-65734 and WD-73734 showcase Mitsubishi's exceptional commitment to high-definition viewing. With screen sizes of 65 and 73 inches, respectively, these models offer large displays that are perfect for movie nights or gaming sessions. The DLP technology utilized in these televisions ensures vibrant colors, deep blacks, and excellent contrast ratios, making images pop on the screen.

One of the standout features of these models is the incorporation of Mitsubishi's 6-Color Processing technology. Traditional televisions typically utilize only three primary colors (red, green, and blue). In contrast, the 6-Color Processing adds additional colors, including yellow, cyan, and magenta, resulting in a more accurate and richer color palette. This technology enhances the overall viewing experience, making it feel more lifelike and immersive.

The WD-65734 and WD-73734 also include Mitsubishi's advanced Brilliant Color technology. This feature optimizes color performance across various brightness levels, making images appear brighter and more vibrant without sacrificing detail in darker scenes. The result is a television that excels in a wide range of lighting conditions, from well-lit rooms to darkened home theaters.

In terms of connectivity, these models offer multiple HDMI ports, allowing users to easily connect their Blu-ray players, gaming consoles, and streaming devices. They also support 1080p resolution, ensuring that viewers can fully enjoy HD content from various sources.

Another notable characteristic is the integrated Motion Estimation/Motion Compensation (MEMC) technology, which helps eliminate motion blur during fast-paced scenes. This is particularly advantageous for sports fans and action movie lovers, as it provides a smoother viewing experience.

Durability and reliability have been key considerations for Mitsubishi Electronics, and both the WD-65734 and WD-73734 are designed to provide long-lasting performance. The LED light source used in these models is not only energy-efficient but also has a longer lifespan compared to traditional lamps.

In summary, the Mitsubishi Electronics WD-65734 and WD-73734 DLP televisions deliver a compelling combination of advanced technology, stunning visual performance, and user-friendly features, making them excellent choices for anyone looking to enhance their home entertainment systems.