Mitsubishi Electronics WD-Y657 manual Lamp-Cartridge Replacement, Lamp-Cartridge Filter Cleaning

Page 62

62Appendices

Appendix C: Lamp-Cartridge Replacement and Cleaning, continued

Lamp-Cartridge Replacement

Removing the Old Lamp Cartridge

1. Turn off TV power and allow the lamp to cool for at

least one hour before proceeding.

2. After the lamp has cooled, remove the cover of the

lamp compartment, located on the back of the TV.

Refer to figures 1 and 2. Use a #2 (large) Phillips

screwdriver to loosen the screw securing the cover.

Keep the screw and cover for re-installation

Figure 1

Figure 2

3.

With a large Phillips or flat-blade screwdriver, loosen

 

the two shiny screws securing the lamp cartridge

 

until they disengage from the mating threads. These

 

are captive screws and cannot be separated from the

 

lamp cartridge.

4.

Fully open the bag supplied with the replacement

 

lamp and set the opened bag aside.

5.

Gently grasp the handle of the lamp cartridge and

 

pull the old cartridge straight out. See figure 3.

Figure 3

Use only replacement lamp part number 915P061010.

CAUTION: Do not tilt or rotate the cartridge, as small glass fragments may fall out.

6.Without tilting or putting down the lamp cartridge, insert it into the opened bag. Close the bag while being careful not to let any glass particles fall out.

Installing the New Lamp Cartridge

1.Do not touch the glass parts of the new lamp car- tridge. Insert the new cartridge into the TV in the same orientation as the old cartridge. Push on the cartridge housing until it is fully seated.

2.With either your fingers or the screwdriver, gently tighten the two shiny screws. If using a screw- driver, AVOID OVERTIGHTENING!

3.Replace the plastic cover and retaining screws.

4.WASH YOUR HANDS THOROUGHLY, AS THIS LAMP CONTAINS MERCURY.

Disposal of the Old Lamp Cartridge

Lamp under warranty: All lamps replaced under war- ranty must be returned to Mitsubishi. Use the return shipping label provided and send to Mitsubishi Digital Electronics, America, 1001 Cherry Drive, Suite 2, Brasel- ton, GA 30517.

IMPORTANT: Lamps found to be without defect will be returned and charged back to the sender.

Lamp no longer under warranty: Contact your local authorities or the Electronic Industries Alliance at www.eiae.org for lamp-disposal or recycling instructions. Do not dispose of the old lamp with common trash.

Lamp-Cartridge Filter Cleaning

If the TV shuts off after displaying the message “TV will shut down in a few seconds. Please check if the air flow is blocked ” and/or the STATUS LED is yellow, the air filter may need cleaning. The air filter is part of the lamp cartridge. Use the following procedure to clean the filter.

1.Remove the lamp cartridge from the TV as described under “Removing the Old Lamp Car- tridge.” Do not tilt or rotate the cartridge. Do not touch the glass parts of the lamp cartridge.

2.Holding the lamp cartridge horizontal (do not tilt or rotate), use a soft dry brush or vacuum cleaner to remove any dust that may be present on the mesh filter. Do not use liquids. See figure 4.

3.Reinstall the lamp cartridge as described under “Installing the New Lamp Cartridge.”

Figure 4

Keep lamp cartridge horizontal and remove dust from the mesh filter using a soft dry brush or vacuum cleaner.

Image 62
Contents WD-57733, WD-65733, WD-73733 WD-C657WD-Y577, WD-Y657 WD-57734, WD-65734, WD-73734Refer Servicing to Qualified Service Personnel For Your RecordsContents Cleaning Recommendations Installation NotesLamp Replacement Operating NotesImportant Safeguards Package Contents Special Features of Your TVFront Inputs TV Front PanelControl Panel Status Indicator Front-Panel IndicatorsLamp Indicator Timer IndicatorComponent Inputs Audio and Video TV Back PanelANT 1/MAIN, ANT 2/AUX Antenna Input 1, 2 Audio and Video IR Emitter NetCommandHdmi Inputs Hdmi Cable CategoriesGetting Started Guidelines for Setting Up and Using Your New Widescreen TVAdditional TV Setup TV OperationInstalling the Remote Control Batteries When You First Power On the TVInitial TV Setup When You First Connect a Device Setting Up TV InputsAdditional TV Setup Using the Setup Menu Change the Menu LanguageMore About Auto Input Sensing Controlling A/V Receiver Sound VolumeWith a Standard TV Setup Computer Video Connection Audio Video Output Connecting a Computer to the TVThis TV accepts digital computer signals only Digital DVIImage Resolution Using the TV with a Personal ComputerComputer Video Adjustments Computer Display FormatsBefore you Begin Hdtv Cable Box or Satellite Receiver with Component Video18 3. TV Connections Antenna with a Single Lead VHF LeadsDVD Player with Component Video %1MBZFSVCR to an Antenna or Wall Outlet Cable VideoVCR to a Cable Box Audio & Video Video LMONO-AUDIO-R Audio Hdmi OUT IR EmitterReceivers with Hdmi Inputs Receiver Sound SystemOlder Cable Box Component Y Pb Pr Video Connection CamcorderComposite Video Connection Hdmi ConnectionTV Tips Sleep TimerChoosing a Viewing Source Remote Control Blank spaceChannelView Channel Listings Ant Signal StrengthStatus Display TV-PG FAV1FAV Favorite Channels ANT-1DVD Definitions TV Signals and Display FormatsSignal Definitions TV Display Format DefinitionsTV Display Formats See descriptions on the precedingViewing Jpeg Picture Files Jpeg Photos and the USB Photo PortSlide Show Media Setup MenuPhotos and Moving Video as Composite Video Keys for Jpeg Picture Slide ShowRemote Control Keys for the TV Menu System Main MenuAV Menu AV Menu OptionsVideo Menu Video Menu OptionsANT1/ANT2 SAP Audio MenuAudio Menu Options ANT1/ANT2Captions on Digital Channels Captions MenuCaptions on Analog Channels Captions Menu OptionsSetup Menu Setup Menu OptionsEdit Virtual Channel Number digital channels onlyPhysical Digital Channel Number ChannelSelect either Applies or Ignore for Daylight Savings Time SettingsClock Timer On, Off Day TimerAVR Inputs MenuInputs Menu Options Parent Menu Setting or Resetting a Pass CodeLock Menu Other Menu Alternate Rating SystemTV-Y7 Parent Menu Options U.S.-based rating systemTV-Y TV-GFront Panel Other Menu Options alternate rating systemTime About NetCommand Important Note on NetCommand0OUPQPGBTJOHMF UBMMEFWJDF IR Emitter Placement NetCommandTFOTPS *OGSPOUPGB TJFEEFWJDFTIf the device has no Power OFF key, skip this step Initial NetCommand Setup for Most DevicesAdd or Remove Device Keys from NetCommand Control CH/PAGE PowerGuide Special Operation Methods To Control an A/V Receiver Operating NetCommand-Controlled DevicesTo Control Most Device Types Inside the Guide Outside the GuideSetting Up NetCommand Control of an A/V Receiver Before You Begin XJUI EJHJUBMTVSSPVOETPVOE 56 6. NetCommand Appendices Appendix a Specifications Width Depth LbsAppendix B Bypassing the Parental Lock Bypassing the Parental LockThis page intentionally left blank To Order a New Lamp Appendix C Lamp-Cartridge Replacement and CleaningLamp Life Lamp Part Number 915P061010Installing the New Lamp Cartridge Lamp-Cartridge ReplacementLamp-Cartridge Filter Cleaning Removing the Old Lamp CartridgeAppendix D Programming the Remote Control Functions Available for Other A/V DevicesAudio Lock Universal A/V Receiver Control Programming the Remote ControlCode Verification Programming Codes Audio Amplifiers Brand CodeCD Players Brand Code Cable Boxes Brand CodeDVD Players/Recorders Brand Code TFCLaser Disc Players Brand Code Satellite Receivers Brand CodeVCRs and DVRs Brand Code ABSSTS Before you change sound or picture settings If Appendix E TroubleshootingTV Reset Comparison Guide Reset Name When to Use How to Use Resulting ActionSupport Service and SupportService General TV Operation Symptom Remarks TV Channels Symptom RemarksTV Power On/Off Symptom Remarks Picture Symptom RemarksSymptom Remarks Indicators Symptom RemarksNetCommand Y and 734 series only Symptom Remarks Trademark and License Information Mitsubishi TV Software Mitsubishi DLP Projection Television Limited Warranty Mitsubishi Digital Electronics AMERICA, INC Index Index Page MDEAservice@mdea.com System Reset
Related manuals
Manual 1 pages 1.68 Kb Manual 2 pages 7.78 Kb Manual 2 pages 27.12 Kb

WD-Y657, WD-Y577, WD-73733, WD-57733, WD-65733 specifications

The Mitsubishi Electronics WD-65734 and WD-73734 are part of the renowned line of DLP (Digital Light Processing) televisions that have garnered a strong following among home theater enthusiasts. These models feature advanced technologies that deliver stunning image quality and an immersive viewing experience.

Both the WD-65734 and WD-73734 showcase Mitsubishi's exceptional commitment to high-definition viewing. With screen sizes of 65 and 73 inches, respectively, these models offer large displays that are perfect for movie nights or gaming sessions. The DLP technology utilized in these televisions ensures vibrant colors, deep blacks, and excellent contrast ratios, making images pop on the screen.

One of the standout features of these models is the incorporation of Mitsubishi's 6-Color Processing technology. Traditional televisions typically utilize only three primary colors (red, green, and blue). In contrast, the 6-Color Processing adds additional colors, including yellow, cyan, and magenta, resulting in a more accurate and richer color palette. This technology enhances the overall viewing experience, making it feel more lifelike and immersive.

The WD-65734 and WD-73734 also include Mitsubishi's advanced Brilliant Color technology. This feature optimizes color performance across various brightness levels, making images appear brighter and more vibrant without sacrificing detail in darker scenes. The result is a television that excels in a wide range of lighting conditions, from well-lit rooms to darkened home theaters.

In terms of connectivity, these models offer multiple HDMI ports, allowing users to easily connect their Blu-ray players, gaming consoles, and streaming devices. They also support 1080p resolution, ensuring that viewers can fully enjoy HD content from various sources.

Another notable characteristic is the integrated Motion Estimation/Motion Compensation (MEMC) technology, which helps eliminate motion blur during fast-paced scenes. This is particularly advantageous for sports fans and action movie lovers, as it provides a smoother viewing experience.

Durability and reliability have been key considerations for Mitsubishi Electronics, and both the WD-65734 and WD-73734 are designed to provide long-lasting performance. The LED light source used in these models is not only energy-efficient but also has a longer lifespan compared to traditional lamps.

In summary, the Mitsubishi Electronics WD-65734 and WD-73734 DLP televisions deliver a compelling combination of advanced technology, stunning visual performance, and user-friendly features, making them excellent choices for anyone looking to enhance their home entertainment systems.