Mitsubishi Electronics PD-6150, PD-5050 manual

Page 40

*1 Overheat protector

If the display becomes too hot, the overheat protector will be activated and the display will be turned off. If this happens, turn off the power to the display and unplug the power cord. If the room where the display is installed is particularly hot, move the display to a cooler location and wait for the display to cool for 60 minutes. If the problem persists, contact your dealer.

*2 In the following case, power off the display immediately and contact your dealer or authorized Service Center.

The display turns off 5 seconds after powering on and then the POWER/STANDBY indicator blinks. It indicates that the power supply circuit, plasma display panel, temperature sensor, or one or more fans have been damaged.

Image 40

Contents Owner’s Guide Important Safety Instructions PD-5050/PD-6150 Precautions Important InformationTo avoid damage and prolong operating life Do not turn off OrbiterPage Plasma Display Screen & Cabinet Cleaning SafeguardsImportant No Abrasives Features you’ll enjoy include Contents of the PackageIntroduction Introduction to the PD-5050/ PD-6150 Plasma DisplaysWhen viewing videos or digital video discs Page Drawing a Power COMPONENT1 Sleep Handling the remote control Battery Installation and ReplacementOperating Range Page Turn on the plasma display and the VCR MonitorLink and MonitorLink Control External Hdmi Device with Hdcp ConnectionCables To adjust the sound volume To cancel the soundTo check the settings Basic OperationsTo cancel the off timer To set the off timerTo check the remaining time When viewing videos or digital video discs Format SizesFormat Operation with Computer Signals Supported resolutionNarrow screen size 43 or Sxga Expand screen sizeMenu Controls Menu OperationsPage Restoring the factory default settings Main menu Sub menuStoring picture settings Picture Settings MenuAdjusting the picture Example Setting NR-3 Reducing noise in the picture NR Types of noise reductionSetting the color temperature Adjusting the color to the desired levelMaking the Low Tone adjustments Changing the Gamma CurveFilm Mode Adjusting the pedestal level black levelColorView Audio Settings Menu Image Adjust Settings MenuSelecting the Input of the audio connectors Adjusting the Position, Size, Fine Picture, Picture AdjSET UP Settings Menu Setting the language for the menusSetting the BNC connectors Setting high definition images to the suitable screen sizeSetting the video signal format Setting the background color when no signal is being inputVideo signal formats Back Ground SettingsSetting the position of the menu Setting the screen size for S1/S2 video inputTurning the display menu on/off Resetting to the default values Refer to pages 15 & 16 for items to be resetFunction Settings Menu Setting the power management for computer imagesPOWER/STANDBY indicator Setting the Input Skip Peak Bright settings Orbiter settings INVERSE/WHITE Settings Soft Focus settingsSignal Information Menu Example Setting Orbiter Menu to OFF Orbiter Menu settings Example Setting Menu Contrast to NormalType of connector D-Sub 9-pin male ApplicationMonitorLink Control Codes Reference Communication ParametersTroubleshooting Symptom Checks RemedyPage PD-5050 Specifications SignalsPD-6150 Specifications Up/downComputer input signals supported by this system KHz 169Page Mitsubishi Plasma Display Panel Limited Warranty Declaration of Conformity