JVC SP-XSV70 Using the remote control, Putting batteries in the remote control, Replace the cover

Getting Started

Using the remote control

The remote control makes it easy to use many of the functions of the system at a distance of up to 7 m (23 feet) away.

•You can also operate other components from the remote control supplied with this system.

–To operate your TV, see page 20.

–To operate your VCR, CATV convertor, or DBS tuner, see page 69.

Putting batteries in the remote control

Before using the remote control, put two supplied batteries first.

1On the back of the remote control, remove the battery cover.

2Insert batteries.

• Make sure to match the polarity: (+) to (+) and (–) to (–).

3Replace the cover.

1 2 3

If the range or effectiveness of the remote control decreases, replace the batteries. Use two R6P (SUM-3)/AA (15F) type dry- cell batteries.

CAUTION:

Follow these precautions to avoid leaking or cracking batteries:

•Place batteries in the remote control so they match the polarity: (+) to (+) and (–) to (–).

•Use the correct type of batteries. Batteries that look similar may differ in voltage.

•Always replace both batteries at the same time.

•Do not expose batteries to heat or flame.

Operating the system from the remote control

Aim the remote control directly at the remote sensor on the center unit.

•To control other components, aim the remote control directly at the remote sensor on each component. Refer also to their instruction manuals .

•To operate the remote control properly, do not hide the remote sensor by placing any obstruction.

SOURCE VOL

D V D D I G I T A L C I N E M A S Y S T E M	Remote sensor
T H - V 7 0

When the center unit is placed vertically

SOURCE VOL

When the center unit is placed horizontally

NOTE:

When the moving panel is open, the remote sensor looks up, so the remote control may not work.

You can use the remote control while the moving panel is shut.

19