JVC SP-PWV70, SP-XSV70 manual Introduction, Checking the supplied accessories, Important cautions

Page 6

Introduction

Notes on handling

Important cautions

Installation of the system

Select a place which is level, dry and neither too hot nor too cold between 5°C and 35°C (41°F and 95°F).

Leave sufficient distance between the system and the TV.

Do not use the system in a place subject to vibrations.

Power cord

Do not handle the power cord with wet hands!

A small amount of power (1.7 watts) is always consumed while the power cord is connected to the wall outlet (the center unit only).

When unplugging the power cord from the wall outlet, always pull the plug, not the power cord.

To prevent malfunction of the system

There are no user-serviceable parts inside. If anything goes wrong, unplug the power cord and consult your dealer.

Do not insert any metallic object into the system.

Do not apply any shock to the moving panel when it is open.

An 8 cm disc cannot be played back in this system. (Do not attempt to insert an 8 cm disc using an adaptor. Doing so will damage the system.)

Do not use any non-standard shape disc (like a heart, flower, or credit card, etc.) available on the market, because it may damage the system.

Do not use a disc with tape, stickers, or paste on it, because damage to the system may result.

Label sticker

Sticker

Paste

Note about copyright laws

Check the copyright laws in your country before recording from DVD Video, Super Video CD (SVCD), Video CD, and Audio CD discs. Recording of copyrighted material may infringe copyright laws.

Note about the copyguard system

The DVD Video discs are protected by the copyguard system. When you connect the system to your VCR directly, the copyguard system activates and the picture may not be played back correctly.

Safety precautions

Avoid moisture, water and dust

Do not place the system in moist or dusty places.

Avoid high temperatures

Do not expose the system to direct sunlight or do not place it near a heating device.

When you are away

When away on travel or otherwise for an extended period of time, remove the plug from the wall outlet.

Do not block the vents

Blocking the vents may damage the system.

Care of the cabinet

When cleaning the system, use a soft cloth and follow the relevant instructions on the use of chemically-coated cloths. Do not use benzene, thinner or other organic solvents including disinfectants. These may cause deformation or discoloring.

• Do not clean the moving panel when it is open.

If water gets inside the system

Turn the system off and remove the plug from the wall outlet, then call the store where you made your purchase. Using the system in this state may cause a fire or electrical shock.

Checking the supplied accessories

Check to be sure you have all of the supplied accessories. The number in the parentheses is the quantity of the pieces supplied.

If anything is missing, contact your dealer immediately.

Remote control (1)

Batteries (2)

Stand (1) (for the center unit)

Legs (2) (for the stand)

FM antenna (1)

AM loop antenna (1)

Power cord (1)

System cord (1)

Video cord (1)

AV COMPULINK cord (1)

Speaker cords

5 m (3): For the left front speaker, right front speaker, and center speaker

10 m (2): For the left rear speaker and right rear speaker (The length of the above speaker cords are approximate.)

Speaker wall brackets (2)

Screws

For the stand (1)

For the speaker wall brackets (2)

Paper pattern (1) (for attaching the center unit to a wall)

2

Image 6
Contents TH-V70 Consists of XV-THV70, SP-PWV70, SP-XSV70, and SP-XCV70Button! XV-THV70 Important for Laser Products XV-THV70 Table of Contents Introduction Checking the supplied accessoriesSafety precautions Important cautionsFront panel Names of parts and controlsCenter unit Rear panelDisplay window Powered subwooferFront Powered subwoofer Display windowNames of parts and controls Remote controlRemote control Source selecting buttonsNTSC/PAL About discsPlayable disc types ALLDisc structure High-resolution still image displayAbout discs Playback Control function PBCWhen placing the center unit Horizontally Setting the DISP.SET selectorWhen placing the center unit vertically Getting startedAttach the legs to the stand When placing the center unit verticallyGetting started For connections, see pages 10 toTo connect a TV without the component video input jacks Connecting a TVConnections To connect a TV with the component video input jacksConnecting the FM and AM antennas AM loop antennaFM antenna Speaker layout Connecting the powered subwooferConnecting the satellite speakers System cord suppliedConnecting the speaker cord to the satellite speakers Connecting the satellite front, center, rear speakersBefore connecting the speaker cord Connecting the speaker cord to the powered subwooferConnecting to an analog component Connecting to a digital componentCenter unit RCA pin plug cord To audio output Connecting the power cord When attaching the AM loop antenna to a wall Installing the equipment on the wallWhen attaching the rear speakers to a wall Attaching speakers to the bracketsWhen attaching the center unit to a wall Example of attachmentPage Operating the system from the remote control Using the remote controlPutting batteries in the remote control Replace the coverRelease TV Try to operate your TV by pressing TV Using the remote control for TV operationsSetting the remote control signal for operating your TV To operate your TVPress Audio to turn the power on Press to turn the power on Basic operationsTurning on/off the system Adjusting volume Press Volume + or -. Press VOL + orSelecting the source to play Turning off the sound temporarily Adjusting the brightnessBasic operations Press MutingVolume control Turning off the power with the timerSetting the subwoofer Phase settingChanging the decode mode Decode buttonProgressive VFP button Interlace O Progressive Changing the scan modePress and hold Progressive VFP for 3 seconds About scan systemInserting and removing a disc When the center unit is placed horizontally, pressBasic playback Preventing screen burn-out with the screen saverStopping playback temporarily Moving back the playback position during DVD playback Basic playbackStopping playback completely Starting playback againLocating a desired selection using Number buttons Searching for a particular pointLocating the beginning of a desired chapter or track Using preset tuning Setting the AM tuner interval spacingTuning in to stations manually To store the preset stationsSelecting the FM reception mode To tune in to a preset stationReducing the noise of AM broadcast DTS Digital Surround Creating the realistic sound fieldsDolby Surround Typical Multichannel 5.1 ch reproductionAll Channel Stereo reproduction Available Surround modes for each input signalDAP Digital Acoustic Processor modes All Channel Stereo Creating sound fieldSelecting the surround mode Creating the realistic sound fieldsAdjust the speakers output levels -10 dB to +10 dB Using DAP Modes and All Channel StereoAdjust the speaker output levels -10 dB to +10 dB Press Test again to stop the test toneAdvanced operations Using the on-screen barContents of the on-screen bar Showing the on-screen barPress on Screen twice Basic operation through the on- screen barChanging the time information Press Cursor ∞/5 to select the desired optionLocating a desired scene from the DVD menu Advanced operationsLocating a desired scene from the disc menu Press TOP Menu or MenuPress Angle Selecting a view angle of DVDSelecting a view angle Press Angle repeatedly to select the desired view angleChanging the subtitle languages and audio languages Showing all view angles on the TVSelecting the subtitle language Press Audio repeatedly to select the desired audio language Selecting the audio languagePress Audio On-screen bar appears on the TV screenSelecting the audio channel Press Cursor ∞/5 to select the desired audio languagePress Audio repeatedly to select the desired audio channel Press Cursor ∞/5 to select the desired audio channels Playing from a specified position on a discLocating a desired chapter from the on-screen bar To correct a mis-entryUse Number buttons 0-9 to enter the time Locating a desired position by specifying the timeLocating a desired scene from the digest display Press DigestSpecial picture playback Frame-by-frame playbackShowing continuous still pictures Press ¡ or Playing back in slow-motionZooming in/out Press Zoom + orTo adjust User 1 or User Changing the VFP settingPress Cursor 3/2 repeatedly to select the VFP mode Repeat steps 2-5 to adjust other parametersPlaying back tracks in random order Changing the track orderPlaying back in the desired order Repeat to program the next stepsRepeating a current title, chapter, or all tracks Press Cursor ∞/5 repeatedly to select the repeat modeRepeat playback Repeating a desired partInsert an MP3 disc MP3 disc playbackBasic operations As many times as required01 / 14 Total Operations through the MP3 control displayMP3 control display OperationsInsert a Jpeg disc Jpeg disc playbackSlide-show Press Zoom + or while the slide-show is paused. See alsoPress Number buttons 0-10, +10 to enter the file number Operations through the Jpeg control displayJpeg control display Press MenuSetting DVD preferences Using the choice menusChoice menus Press Cursor 5/∞ repeatedly to select the desired option Basic procedure through the choice menusPress Choice Choice button Cursor and Enter buttonsItems Contents and guidelines Setting DVD preferencesLanguage codes list Language menuPicture menu Audio menu SPK. Setting menu Size menuLevel menu Distance menuOthers menu Choice button Setting Parental LockRestricting playback by Parental Lock Cursor Enter buttonsNew setting is stored Changing the setting of Parental LockPress Number buttons 0-9 to enter your password Releasing Parental Lock temporarilyCountry/Area codes list for Parental Lock Press Cursor 2/3 to make an adjustment Setting the system through the display windowPress Setting Repeat steps 2 and 3 to set other itemsConnecting a TV and VCR AV Compu Link remote control systemConnection and setup Set the AV Compu Link setting in the Others menu as followsInsert a disc into the center unit One-touch DVD playOperating other manufacturers’ video equipment For operating your Catv converter or DBS tunerChannel + Using the remote control for VCR For operating your VCRRelease VCR Try to operate your VCR by pressing VCR General Notes MaintenanceCleaning the system Handling DiscsTroubleshooting GeneralTroubleshooting DVD PlaybackMP3 Playback Jpeg PlaybackOthers Glossary Refers to individual chapters included in a titleSpecifications Specifications Amplifier section0602TMMMDWJEM