JVC SP-PWV70, SP-XSV70 manual SPK. Setting menu, Size menu

Page 64

SPK. SETTING menu

SPK. SETTING

SIZE

LEVEL

DISTANCE

CROSS OVER

200 Hz

RETURN TO INITIAL

Items

 

Contents and guidelines

SIZE

Enters the SIZE sub-menu (the speaker size setting menu). (See below.)

 

 

LEVEL

Enters the LEVEL sub-menu (the speaker level setting menu). (See page 61.)

 

 

DISTANCE

Enters the DISTANCE sub-menu (the speaker distance setting menu). (See page 61.)

 

 

 

CROSS OVER*

200 Hz (Select this when using the supplied speakers. )

Small speakers cannot

 

Select this when the cone speaker unit built in the smallest speaker connected is about

reproduce the bass sounds

 

4 cm.

efficiently. If you use a small

150 Hz

speaker in any position, this unit

 

Select this when the cone speaker unit built in the smallest speaker connected is about

automatically reallocates the

 

6 cm.

bass sound elements assigned

120 Hz

to the small speaker to the large

 

Select this when the cone speaker unit built in the smallest speaker connected is about

speakers.

 

8 cm.

To use this function properly, set

100 Hz

this crossover frequency level

 

Select this when the cone speaker unit built in the smallest speaker connected is about

according to the size of the

 

10 cm.

smallest speaker connected.

80 Hz

 

 

Select this when the cone speaker unit built in the smallest speaker connected is about

 

 

12 cm.

 

 

RETURN TO INITIAL

Resets all speaker settings to the inital settings

 

 

 

* If you have selected “LARGE” for all speakers in the SIZE menu, this function will not take effect.

SIZE menu

CAUTION:

When using the supplied speakers, select “SMALL” for each. Selecting “LARGE” may damage the speakers.

SIZE

 

FRONT SPEAKER

SMALL

CENTER SPEAKER

SMALL

REAR SPEAKER

SMALL

SUB WOOFER

USE

RETURN

 

NOTE:

When “SMALL” is selected for the front speakers, you cannot select “LARGE” for the center speaker and rear speakers.

Items

 

Contents and guidelines

FRONT SPEAKER

LARGE

CENTER SPEAKER

 

Select this when the cone speaker unit built in the speaker is larger than 12 cm.

REAR SPEAKER

SMALL (Select this when using the supplied speakers. )

Select the speaker size

 

Select this when the cone speaker unit built in the speaker is smaller than 12 cm.

according to the size of your

NONE

speakers. (You cannot select

 

Select this when the center speaker and/or rear speakers are not connected or not in

“NONE” for the front speakers.)

 

use.

 

 

SUB WOOFER

USE

 

You cannot select this item.

 

 

RETURN

Returns to the SPK. SETTING menu.

 

 

 

60

Image 64
Contents TH-V70 Consists of XV-THV70, SP-PWV70, SP-XSV70, and SP-XCV70Button! XV-THV70 Important for Laser Products XV-THV70 Table of Contents Checking the supplied accessories Safety precautionsIntroduction Important cautionsNames of parts and controls Center unitFront panel Rear panelPowered subwoofer Front Powered subwooferDisplay window Display windowRemote control Remote controlNames of parts and controls Source selecting buttonsAbout discs Playable disc typesNTSC/PAL ALLHigh-resolution still image display About discsDisc structure Playback Control function PBCSetting the DISP.SET selector When placing the center unit verticallyWhen placing the center unit Horizontally Getting startedWhen placing the center unit vertically Getting startedAttach the legs to the stand For connections, see pages 10 toConnecting a TV ConnectionsTo connect a TV without the component video input jacks To connect a TV with the component video input jacksAM loop antenna Connecting the FM and AM antennasFM antenna Connecting the powered subwoofer Connecting the satellite speakersSpeaker layout System cord suppliedConnecting the satellite front, center, rear speakers Before connecting the speaker cordConnecting the speaker cord to the satellite speakers Connecting the speaker cord to the powered subwooferConnecting to a digital component Connecting to an analog componentCenter unit RCA pin plug cord To audio output Connecting the power cord Installing the equipment on the wall When attaching the rear speakers to a wallWhen attaching the AM loop antenna to a wall Attaching speakers to the bracketsWhen attaching the center unit to a wall Example of attachmentPage Using the remote control Putting batteries in the remote controlOperating the system from the remote control Replace the coverUsing the remote control for TV operations Setting the remote control signal for operating your TVRelease TV Try to operate your TV by pressing TV To operate your TVBasic operations Press Audio to turn the power on Press to turn the power onTurning on/off the system Press Volume + or -. Press VOL + or Adjusting volumeSelecting the source to play Adjusting the brightness Basic operationsTurning off the sound temporarily Press MutingTurning off the power with the timer Setting the subwooferVolume control Phase settingDecode button Changing the decode modeProgressive VFP button Changing the scan mode Press and hold Progressive VFP for 3 secondsInterlace O Progressive About scan systemWhen the center unit is placed horizontally, press Basic playbackInserting and removing a disc Preventing screen burn-out with the screen saverStopping playback temporarily Basic playback Stopping playback completelyMoving back the playback position during DVD playback Starting playback againSearching for a particular point Locating a desired selection using Number buttonsLocating the beginning of a desired chapter or track Setting the AM tuner interval spacing Tuning in to stations manuallyUsing preset tuning To store the preset stationsTo tune in to a preset station Selecting the FM reception modeReducing the noise of AM broadcast Creating the realistic sound fields Dolby SurroundDTS Digital Surround Typical Multichannel 5.1 ch reproductionAvailable Surround modes for each input signal DAP Digital Acoustic Processor modes All Channel StereoAll Channel Stereo reproduction Creating sound fieldSelecting the surround mode Creating the realistic sound fieldsUsing DAP Modes and All Channel Stereo Adjust the speaker output levels -10 dB to +10 dBAdjust the speakers output levels -10 dB to +10 dB Press Test again to stop the test toneUsing the on-screen bar Contents of the on-screen barAdvanced operations Showing the on-screen barBasic operation through the on- screen bar Changing the time informationPress on Screen twice Press Cursor ∞/5 to select the desired optionAdvanced operations Locating a desired scene from the disc menuLocating a desired scene from the DVD menu Press TOP Menu or MenuSelecting a view angle of DVD Selecting a view anglePress Angle Press Angle repeatedly to select the desired view angleShowing all view angles on the TV Changing the subtitle languages and audio languagesSelecting the subtitle language Selecting the audio language Press AudioPress Audio repeatedly to select the desired audio language On-screen bar appears on the TV screenPress Cursor ∞/5 to select the desired audio language Selecting the audio channelPress Audio repeatedly to select the desired audio channel Playing from a specified position on a disc Locating a desired chapter from the on-screen barPress Cursor ∞/5 to select the desired audio channels To correct a mis-entryLocating a desired position by specifying the time Locating a desired scene from the digest displayUse Number buttons 0-9 to enter the time Press DigestFrame-by-frame playback Special picture playbackShowing continuous still pictures Playing back in slow-motion Zooming in/outPress ¡ or Press Zoom + orChanging the VFP setting Press Cursor 3/2 repeatedly to select the VFP modeTo adjust User 1 or User Repeat steps 2-5 to adjust other parametersChanging the track order Playing back in the desired orderPlaying back tracks in random order Repeat to program the next stepsPress Cursor ∞/5 repeatedly to select the repeat mode Repeat playbackRepeating a current title, chapter, or all tracks Repeating a desired partMP3 disc playback Basic operationsInsert an MP3 disc As many times as requiredOperations through the MP3 control display MP3 control display01 / 14 Total OperationsJpeg disc playback Slide-showInsert a Jpeg disc Press Zoom + or while the slide-show is paused. See alsoOperations through the Jpeg control display Jpeg control displayPress Number buttons 0-10, +10 to enter the file number Press MenuUsing the choice menus Setting DVD preferencesChoice menus Basic procedure through the choice menus Press ChoicePress Cursor 5/∞ repeatedly to select the desired option Choice button Cursor and Enter buttonsSetting DVD preferences Language codes listItems Contents and guidelines Language menuPicture menu Audio menu SPK. Setting menu Size menuLevel menu Distance menuOthers menu Setting Parental Lock Restricting playback by Parental LockChoice button Cursor Enter buttonsChanging the setting of Parental Lock Press Number buttons 0-9 to enter your passwordNew setting is stored Releasing Parental Lock temporarilyCountry/Area codes list for Parental Lock Setting the system through the display window Press SettingPress Cursor 2/3 to make an adjustment Repeat steps 2 and 3 to set other itemsAV Compu Link remote control system Connection and setupConnecting a TV and VCR Set the AV Compu Link setting in the Others menu as followsInsert a disc into the center unit One-touch DVD playFor operating your Catv converter or DBS tuner Operating other manufacturers’ video equipmentChannel + For operating your VCR Using the remote control for VCRRelease VCR Try to operate your VCR by pressing VCR Maintenance Cleaning the systemGeneral Notes Handling DiscsTroubleshooting GeneralTroubleshooting DVD PlaybackJpeg Playback MP3 PlaybackOthers Glossary Refers to individual chapters included in a titleSpecifications Specifications Amplifier section0602TMMMDWJEM