JVC HR-XVC11BJ manual Remote Control Function, Remote Control A/B/C Code Switching

Remote Control Function

Remote Control A/B/C Code Switching

The remote control is capable of controlling three JVC video units independently. Each of the units can respond to one of three codes (A, B or C). The remote control is preset to send C code signals because your unit is initially set to respond to C code signals. You can easily modify your unit to respond to A or B code signals.

1/ I B

ENTER

x

1-3

RM-SHRXVC11A

•Keep pressing ENTER (OK) down during step 1.

1.Press the number Key “1” for A, “2” for B or “3” for C to change the remote control code.

2.Ensure the unit in VCR mode, and then turn off the power.

3.Press B on the unit for over 5 seconds while the unit is turned off. The code currently set appears on the front display panel.

4.Press x (STOP) on the remote control to change the unit's code. The code currently set on the remote control blinks on the front display panel for approximately 5 seconds, and is applied to the unit.

Preparation

17