Appendices
Image has slanted sides
vUse of Keystone is not recommended.
4If possible, reposition the projector so that it is centered on the screen and below the bottom of the screen.
4Press [Keystone
Image is reversed
4Select Setup Projection from the OSD and adjust the projection direction.
Intermission Problems
The projector stops responding to all controls
4If possible, turn off the projector, then unplug the power cord and wait at least 60 seconds before reconnecting power.
Lamp burns out or makes a popping sound
4When the lamp reaches its end of life, it will burn out and may make a loud popping sound. If this happens, the projector will not turn on until the lamp module has been replaced. To replace the lamp, follow the procedures in Replacing the Lamp on page 60.
English 56