Optoma Technology EX530, EX520, ES522RFBA manual Replacing the Lamp

Page 60

Appendices

Replacing the Lamp

The projection lamp should be replaced when it burns out. It should only be replaced with a certified replacement part, which you can order from your local dealer.

Important:

4The lamp contains a certain amount of mercury and should be disposed of according to local ordinance regulations.

4Avoid touching the glass surface of the new lamp, doing so may shorten its operation life.

Warning:

4Be sure to turn off and unplug the projector at least an hour before replacing the lamp. Failure to do so could result in a severe burn.

1.Loosen the two captive screws on the lamp compartment cover.

2.Remove the lamp compartment cover.

3.Remove the two screws from the lamp module.

4.Lift the module handle up and pull firmly on the module handle to remove the lamp module.

5.Insert the replacement lamp and push down firmly. Tighten the captive screws to hold the lamp in place.

6.Replace the lamp compartment lid and tighten the captive screws.

After replacing the lamp, the lamp hours counter must be reset. See page 47 for more information.

English 60

Image 60
Contents Table of Contents Safety Information Important Safety Instruction English Precautions Do not Eye Safety Warnings Product Features Video CompatibilityPackage Overview Focus Kensington Lock Lens Tilt-Adjustment Foot Lens CAP Elevator foot Power Socket Elevator buttonProduct Overview Control Panel Front IR Receiver11 10 9 8 7 Control PanelRear View Remote Control Connecting the Projector Connect to Computer / NotebookConnect to Video Sources Powering On/Off the Projector Powering On the ProjectorPowering Off the Projector Adjusting the Projected Image Adjusting the Projector’s HeightTo raise the image To lower the imageAdjusting the Zoom / Focus Zoom Series Adjusting Projection Image Size Zoom Series Height WidthAdjusting the Focus Fixed Zoom Series Adjusting Projection Image SizeDisabled in OSD menus Control PanelKeystone+ Up arrowRemote Control Using the Remote ControlVGA- in connector Press VGA to choose source fromVideo Press Video to choose Composite Video source How to operate On-screen Display MenusMenu Tree Display Mode ImageBrightness ContrastColor Setting SaturationTint AdvancedImage Color Setting ResetGain BiasImage Advanced Image Advanced Input Source Display FormatOverscan ZoomImage Shift Image Shift 169 onlySetup LanguageProjection Menu LocationSignal SecurityProjector ID AudioSetup Language Setup Signal PhaseFrequency PositionSetup Security Security TimerChange Password Security Setting Setup Audio VolumeMute Setup Network Network RJ45 Models OnlySetup Advanced LogoLogo Capture Closed CaptioningOptions Source LockHigh Altitude Information HideLamp Setting Keypad LockBackground Color Direct Power On Auto Power OffSleep Timer Options AdvancedOptions Lamp Setting Brightness ModeLamp Hour Lamp ReminderLamp Reset LANRJ45 RJ45 models only LANRJ45Click Properties Open a web browser ex, Microsoft Internet Explorer Troubleshooting Help On-screen Display Menu Image ProblemsPartial, scrolling or incorrectly displayed image Appendices Image is unstable or flickering Image has vertical flickering bar Intermission Problems Image has slanted sidesMessage Power LED Lamp LED Temp LED Projector Status IndicationRemote Control Problems Message RemindersAudio Problems There is no soundSound is distorted Replacing the Lamp Cleaning the Projector Cleaning the LensSignal Resolution Refresh Rate Hz Compatibility ModesAppendices Apple Mac CompatibilityRS232 Commands RS232 ConnectorRS232 Commands RS232 Protocol Function ListSTD Send to Remote Ceiling Installation Optoma Global Offices Latin America Regulation & Safety notices FCC noticeOperation conditions Remarque à l’intention des utilisateurs canadiensDeclaration of Conformity for EU countries