Honeywell HRDP DVR manual Setting Up Motion Detection Recording

Performance Series DVR User Guide

Setting Up Motion Detection Recording

To record data only when motion is detected:

CHT MOTION			SENS	AREA	SENSOR V-LOSS			TEXT-IN
1	ON		NORMAL	`		OFF	OFF	ON
2	ON		NORMAL	`		OFF	OFF	ON
3	ON		NORMAL	`		OFF	OFF	ON
4	ON		NORMAL	`		OFF	OFF	ON
5	ON		NORMAL	`		OFF	OFF	ON
6	ON		NORMAL	`		OFF	OFF	ON
7	ON		NORMAL	`		OFF	OFF	ON
8	ON		NORMAL `			OFF	OFF	ON
9CH-16CH
INPUT		SENSOR		ACTION		ALARM MONITOR

1.Press Setup on the front of the DVR or remote control.

2.Select Record > Motion/Event Configuration and set MOTION to On.

3.Set SENS level. [Normal / High / Highest / Low].

4.Select AREA and press ENTER to set a motion area (global setting; each channel can be configured individually).

5.Use the arrow buttons and the numeric buttons 1, 2 and 3 to navigate the motion area grid. (Selected motion areas are highlighted green on the grid.)

1 = Set Mode 2 = Clear Mode 3 = Move Mode

a.Press 3 on the front of the DVR or remote control.

b.Use the arrow buttons to move the cursor to the desired location on the screen.

c.Press 1 on the front of the DVR or remote control.

d.Use the arrow buttons to highlight the desired motion detection area.

e.Repeat the steps above to create additional motion detection areas.

6.When finished selecting motion areas press ENTER on the front of the DVR or remote control to save changes.

7.Repeat as necessary for each channel.

8.When motion area setup is complete select SAVE to save settings and exit setup.

______________________________________________________________________________________________

Document 800-02089 Rev B 43

06/08