Setup
Client Configuration
Configure general remote access.
REMOTE PORT | 2000 |
WEB PORT | 80 |
REMOTE CONFIG | ENABLE |
MAX TRANSFER SPEED | 100 Mbps |
Remote Port – Use this port number when configuring remote access software. The default port is 2000 but can be changed.
Web Port – Used for remote connections using a web browser. This port should be open on the router. Default web port is 80.
Remote Config – Enable to allow an administrator to change configurations using remote access software.
Max Transfer Speed – Set network bandwidth. If the network is low speed, set this value as the network (aka. Bandwidth Throttling).
______________________________________________________________________________________________
48