SAFETY PRECAUTIONS (continued)
Main Unit Installation
When installing the main unit, be sure to use the specified mounting units in order to obtain maximum performance and maintain safety.
Hitachi assumes no responsibility nor liability for personal injuries or property damage caused by use of other mounting units or improper installation.
With respect to installation instructions, please read each user manual for the respective mounting units: for Tabletop Setup, Floor Stand Setup, Wall Mounting, and Ceiling Mounting.
If using Wall or Ceiling Mounting units, contact your local dealer and ask for an approved installation specialist to set up the unit. Never attempt to install it yourself. That could cause injury or damage.
Please leave adequate space around the unit in order to avoid increasing the internal temperature.
Make sure not to block any ventilation holes.
Do not install the unit in a small space such as inside a cabinet, closet or box without adequate ventilation. Leave at least 10cm (4") of clearance from each side of the unit and 30cm (1') from the top of the unit to ceiling.
10cm (4”) |
or more |
| 30cm (1’) |
| or more |
10cm (4”) | 10cm (4”) |
or more | or more |
10cm (4”) or more
Anti-tumble Measures
Install in a stable location and take safety precautions against overturning.
Securing to a table
1 Remove the plastic rivet.
Plastic rivet
| Fasten the fastening strap to a table using | |
2 | ||
the wood screw provided. |
Wood screw
(4 x 20 screw) : 1 pc.
Fastening strap
Securing to ceiling or wall
Use the specified mounting unit to secure the set to a ceiling. For Wall Mounting setup please refer to page ( 11 ).
For Floor Stand setup please refer to page ( 12 ).
NOTE
For more information regarding mounting of the unit, please contact
Please install the unit in a proper location where it does not expose anyone to the danger of bumping themselves (for example their hands, head or face, etc) against the edges of the unit and causing personal injury.
9