TV Setup Wizard
Your Hitachi LCD television has a TV Setup Wizard feature which has the ability to help you easily setup the first time you turn on your TV and find the channels available in your area. Please follow the instructions below.
FIRST
The First time you turn on your Hitachi LCD TV the setup wizard screen will appear. The first step is to set the language of your TV On Screen Menu. Select the language that you prefer. Use the and CURSOR to select language and press the SELECT button on the remote control.
Setup Wizard (1/7)
Please select language ...
English
Español
Français
Cancel
Navigate | SEL Select |
The second and third steps are to set the date and time. There are two options; one for automatic time setting in which you will select only the time zone in your area and the second option is a manual setup for the date and time. Use the CURSOR pad to select and change the options with the remote control.
The fifth step will start the scanning feature to find the channels available on the antenna or cable system. Press the SELECT button on the remote control to start the channel scan.
Setup Wizard (5/7)
Please check that the RF cable is connected properly.
| Start |
Previous | Cancel |
Navigate | SEL Select |
The sixth step is the scanning process of the channels, it will first the scan the analog channels and then the digital channels. The scanning process will show how many channels have been found. Please be patient while the scanning process searches for the available channels in your area. If you wish to cancel the process, press the SELECT button on the remote control.
TIME USE
Setup Wizard (2/7)
Please set time mode ...
Auto
Manual
Previous | Cancel |
Navigate | SEL Select |
Setup Wizard (3/7)
Please select Time Zone ...
NST MST
AST PST
EST AKST
CST HST
Previous | Cancel |
Navigate | SEL Select |
Setup Wizard (3/7)
Please enter the date and time ...
Year | 2009 |
Month | Jan |
Date | 1 |
Time | 12:00 AM |
| OK |
Previous | Cancel |
Navigate | SEL Select |
Setup Wizard (6/7) |
|
| |
Searching, please wait ... |
|
| |
Searching Analog CH | Channel 3 | ||
Analog Channels Found | 10 |
| |
Digital Channels Found | 15 |
| |
10% |
|
|
|
|
|
| |
|
|
| |
Cancel
SEL Cancel
NOTES • Once the user cancels the wizard, the wizard will not be shown again.
• If you see the screen above and if you did not |
connect your Antenna cables to your TV, turn off |
your TV, unplug the power cord and connect your |
cables according to the applicable connections |
in the “First Time Use” section of this Operating |
Guide. |
• After completing the TV Setup Wizard, these |
screens will not appear again. For updating and |
adding the channels available in your area refer to |
The fourth step is designed to find broadcasting or cable channels. There are two options, Air for an external antenna and Cable for a cable system provider in your home. Use the
and CURSOR to select a source and press the SELECT button on the remote control.
Setup Wizard (4/7)
Please select TV RF tuning band ...
Air
Cable
Previous | Cancel |
Navigate | SEL Select |
the Add Channels to List feature on page 40. |
The last step is the completion of process, it shows a brief message and you are ready to view TV programing. This final message will be shown for a few seconds and then the first detected channel will be tuned in. You may also press EXIT on the remote control to tune to the first detected channel.
Setup Wizard (7/7)
Congratulations. TV setup is done.
EXIT Exit
13