How To Install Your New Hitachi LCD Television
Take the following precautions to prevent the LCD Television from tipping over and possibly causing injury. It is important to mount the unit on a stable and flat surface.
FIRST
ASSEMBLY OF THE BASE
IMPORTANT:
The base of the LCD TV must be assembled prior to use.
1.Place the TV unit face down on a soft and flat surface covered by a blanket, foam, cloth, etc. to prevent any damage or scratches to the LCD TV.
2.Carefully align and insert the Base to the TV stand post.
3.Insert the screws included with the accessories to the bottom of the base and tighten the base to the stand.
Caution when moving the main unit
As this product is heavy, whenever it is moved, at least two people are required to transport it safely. Whenever the unit is moved it should be lifted forward using the top and base on both sides of the Television for stability.
When moving the Television, lift from the corners, then support the top frame as shown below.
Please use caution when handling the left and right bottom corners of the TV, as these areas protrude slightly from the TV’s frame. Handle this area with care to avoid damaging the unit and the possibility of personal injury.
Location
Select an area where sunlight or bright indoor illumination will not fall directly on the picture screen. If so, drapes or screens can be used to reduce the reflection.
Also, be sure that the location selected allows a free flow of air to and from the perforated back cover of the set. In order to prevent an internal temperature increase, maintain a space of 10 cm (4 inches) from the sides/back of the Television, and 30 cm (12 inches) from the top of the television to the ceiling. To avoid cabinet warping, cabinet color changes, and increased chance of set failure, do not place the TV where temperatures can become excessively hot, for example, in direct sunlight or near a heating appliance, etc.
| 30 cm (12 inches) |
10 cm | 10 cm |
(4 inches) | (4 inches) |
• Do not block the ventilation holes of the LCD
NOTES
Television. Blocking the ventilation holes might cause overheating and damage.
•In case of an abnormal symptom, unplug the AC cord and contact
•If you purchased a wall mount bracket, please ask for professional installation. Do not try to install by yourself.
• Install the unit at a proper area where it does not expose anyone to any danger of hitting themselves (for example their hands, head or face, etc.) against the edge of the unit that could cause personal injury.
Power Cord Installation
The Power cord provided with your new LCD Television needs to be installed correctly to avoid its disconnection when rotating the TV on its Table Top Stand.
Located on the back of the TV there is one plastic clamp to hold the Power cord. Please follow the instructions below.
Pass the Power cord through the clamp and connect it to the TV.
Close the clamp to fix the Power cord to the TV.
All the cables connected to the TV will be held by this clamp.
AC Wire Clamp
Securing to a Wall
1.Use a metallic wire (two locations) to fasten the set to the clamping screw on the rear of the LCD TV as shown below.
2.Keep the LCD television 4 inches away from the wall, except when mounted using the wall mount bracket, and secure to the wall as shown below:
A
Wire
Wire
Wire
Screw Clamp
| A |
46” | 4 in. |
| |
55” | 10 cm. |
TIME USE
7