PREPARATION
Remote Control Batteries Installation Handling the Remote Control
This remote control operates on 2 “AA” batteries.
1. Open the battery compartment cover
Ɣ Slide open the battery compartment cover on the backside in the direction of an arrow, and remove the cover.
2. Installing the batteries
Ɣ Install 2 “AA” batteries (included) making sure the polarities match the indication
inside the compartment. | Holes |
|
Projecting parts
3. Close the battery compartment cover
Ɣ Make sure of the positions to fit the projecting parts in the holes, and slide the compartment cover in the direction of an arrow till it clicks shut.
Use the remote control within about 5m from front of the unit’s
Within 30 degrees | Within 30 degrees |
| |
About 3m | About 3m |
| |
| About 5m |
CAUTION 
It could cause corrosion or battery leakage and may result in physical injury and/or property damage including fire.
Ⴠ Never mix used and new batteries in the device.
Ⴠ Replace all the batteries in a device at the same time.
Ⴠ Remove the batteries if the remote control is not going to be used for an extended period of time.
To avoid possible failure, read the following instructions and handle the remote control properly.
ƔDo not drop or have an impact on the remote control.
ƔDo not spill water or any liquid on the remote control.
ƔDo not place the remote control on the wet object.
ƔDo not place the remote control under the direct sunlight or near sources of excessive heat.
Caution When Moving the Main Unit
As this product is heavy, whenever it is moved, two people are required to transport it safely.
When moving the unit, hold it by the top and bottom frame of the LCD screen. (See the figures below for details.)
L37X01AU | L42X01AU |
| Hand grips |
13