Hitachi L42X01AU, L37X01AU manual Installing Channels, Restoring Channels

DIGITAL TERRESTRIAL TELEVISION (DTT) OPERATION (continued)

Installing Channels

You can search available channels in any of the following 3 methods.

1.Press button on the remote control in DTT mode.

2.Select “Installation”, on the DTT main menu with buttons and press button.

3.The password is required to enter the Installation menu. The initial password is 0000.

4.You can select either of the followings by pressing button.

ξManual scan: Searches by individual settings manually.

The box shown on the right appears. Fill out the following 4 items as needed.

Channel	Use	buttons or numeric button to enter the number.
	(Ch2-Ch69) *In case of tuning Ch9A, select Ch2
num
	(Frequency: 205.5MHz.).
Frequency	Use numeric button to enter the frequency.
Bandwidth	Select either 7MHz or 8MHz by using			buttons. Set to
	7MHz normally.
Priority	Select	High or Low by using	buttons. Set to High
	normally.

Then, press button on “Start scan” of “Manual scan” column. If it finds a channel, “Success” shows up. If not, “Timeout error” is displayed.

ξQuick scan: Searches channels of the selected area.

The list of the area shows up. Select one of those with	buttons and press
button.

NOTE

Installation	Channel num	6
Manual scan	Frequency	177500KHz
Quick scan	Bandwidth	7 MHz
Auto scan	Priority	High
Restore default	Manual scan	Start scan

Installation	Adelaide
Manual scan	Brisbane
Quick scan	Melbourne
Auto scan	Perth
Restore default	Sydney

Batchelor

Canberra

Darwin

Press Ÿźto select city.

ξIf you are uncertain about the area, please select “Auto scan” method or contact the local dealer in your area.

ξAuto scan: Searches every channel.

The message “Auto scan will take more than 10 minutes. Do you want to continue?”

Select “Yes” and press button to precede it.

Restoring Channels

This restores the all channel settings.

1.Press button on the remote control in DTT mode.

2.Select “Installation”, on the DTT main menu with buttons and press button.

3.The password is required to enter the Installation menu. The initial password is 0000.

4.Select “Restore default” and press button. The message “All setting

would be lost” appears. Select “Yes” and press button.

NOTE

ξThe password will return to the default setting when activating “Restore default”

Installation	Auto scan will take more
Manual scan	than 10 minutes.
	Do you want to continue?
Quick scan
		Yes	Exit
Auto scan
Restore default

Installation	All setting would be lost.
Manual scan	Yes	Exit

Quick scan

Auto scan

Restore default

40