CONNECTION (continued)
Connecting Procedure (continued)
1. Connecting Power Cord to Rear Panel.
Connect power cord to the television.
*Make sure not to connect the power plug to the wall socket until all connections are completed.
2.Connecting Aerial Lead.
There are two ways to connect aerial lead.
When you do not have any other external equipment
Connect the aerial lead directly into the socket at rear panel.
When you have one or more external devices to connect:
1.Use RF cable to connect between each equipment and aerial.
2.Connect the Aerial Lead to an equipment ”In” socket marked
3.Connect the RF cable from the equipment “Out” to the other equipment “In”.
4.Then, connect from the equipment ”Out” to “ANT” on the LCD screen socket.
STB VCR
[Example: Connecting Antenna through STB and VCR.]
Precautions when connecting the aerial
ƔPlease use a coaxial cable which is free from interference to connect the aerial. Avoid using a parallel flat feeder wire as interference may occur, causing reception to be unstable and stripe noise to appear on the screen.
ƔAvoid using indoor aerial as this may be affected by interference. Please use CATV net or outdoor aerial.
ƔFor safety, install an external aerial conforming to AS1417.1( Applicable for Australia only)
ƔIf there are noise in the picture of
16