Hitachi P50V701 important safety instructions AV Net Setup Wizard Custom Settings

Setup

5.Use the CURSOR PAD ￿ or ￿ to select “Other” from brand name choices.

6.Use the CURSOR PAD ￿ or ￿ to highlight “Learning Mode” then press the SELECT button.

AV Net Setup Wizard : A/V Receiver Setup

Please choose the Brand Name of your A/V Receiver. If you can not find the Brand Name, please choose “Other” and proceed to the Learning mode by pushing the Learning Mode Button.

Brand Name Other

Learning Mode

BackNext

Move Change Brand Name

7.Use the CURSOR PAD ￿, ￿, ￿ and ￿ to select the Soft Key to learn (Ex. VOL ￿), then press the SELECT button.

AV Net Setup Wizard : Custom Settings

Select the A/V Receiver softkey to learn?

TV Softkeys

POWER	CH￿	VOL￿
MUTE	CH￿	VOL￿	AUDIO
SOURCE 1	SOURCE 2	SOURCE 3	SOURCE 4	SOURCE 5
SOURCE 6	SOURCE 7	SOURCE 8	SOURCE 9	SOURCE 10
			Back		Done
Move	SEL Select

8.Press and hold the VOL ￿ button of your A/V Receiver remote control while pointing directly at the learning AV NET sensor of the Plasma TV (located at the lower right corner of the screen) at a distance of 3.2 feet or 1 meter maximum.

AV Net Setup Wizard : A/V Receiver Setup

Press and hold desired button to transfer the command to AV NET.

VOL￿

Please wait while AV NET

Learns the command....

Move SEL Select

9.If the IR code transfer was not completed, the screen below appears. Repeat step 8 to try again.

AV Net Setup Wizard : A/V Receiver Setup
		VOL￿
		Transfer not completed!
		Try again?
		Cancel	OK
Move	SEL	Select

10.If the IR code transfer was successful, the screen below appears, then select “OK” to continue setup.

AV Net Setup Wizard : A/V Receiver Setup

VOL￿

Transfer was successful.

Press OK to store and continue.

CancelOK

Move SEL Select

11.Select another Soft Key to learn or select DONE to move on to the next screen.

12.Select the Test button VOL ￿ to check the response of the device to this command. Test Buttons will show you first learned keys with a maximum of 3.

13.Use the CURSOR PAD ￿, ￿, ￿ and ￿ to highlight NEXT, then press the SELECT button to move on to the next SETUP screen.

AV Net Setup Wizard : A/V Receiver Setup

Select the Test button. If device responds to this command, proceed to “Next”. Otherwise, try another IR Code Set number.

Brand Name	Other
IR Code Set	Other
	Learning Mode
Test Button	VOL ￿

BackNext

Move SEL IR Out

14.Use the CURSOR PAD ￿ or ￿ to select the TV Input that connects to the video and audio output of the A/V Receiver.

15.Use the CURSOR PAD ￿, ￿, ￿ and ￿ to highlight NEXT, then press the SELECT button to move on to the next SETUP screen.

On-Screen Display

71