![](/images/new-backgrounds/1204939/20493919x1.webp)
Preparation |
| Note: Remove the battery from remote control hand- | |||||||||
| set when it is not to be used for a long period. Other- | ||||||||||
For ventilation, leave a space of at least 10 cm free all | |||||||||||
wise it can be damaged due to any leakage of bat- | |||||||||||
around the set. To prevent any fault and unsafe situ- | tery. | ||||||||||
ations, please do not place any objects on top of the | Handling the Remote Control | ||||||||||
set. | • It could cause corrosion or battery leakage and may | ||||||||||
Use this apparatus in moderate climates. | |||||||||||
result in physical injury and/or property damage in- | |||||||||||
|
|
|
|
|
|
|
| ||||
|
|
|
|
|
|
|
| cluding fire. | |||
|
|
|
|
|
|
|
| • Never mix used and new batteries in the device. | |||
|
|
|
|
|
|
|
| ||||
|
|
|
|
|
|
|
| ||||
|
|
|
|
|
|
|
| • Replace all the batteries in a device at the same time. | |||
|
|
|
|
|
|
|
| • Remove the batteries if the remote control is not | |||
|
|
|
|
|
|
|
| going to be used for an extended period of time. | |||
|
|
|
|
|
|
|
| • To avoid possible failure, read the following instruc- | |||
|
|
|
|
|
|
|
| ||||
|
|
|
|
|
|
|
| tions and handle the remote control properly. | |||
|
|
|
|
|
|
|
| • Do not drop or cause impact to the remote control. | |||
Before Switching On Your TV |
| ||||||||||
| • Do not spill water or any liquid on the remote control. | ||||||||||
Power Connection | |||||||||||
• Do not place the remote control on a wet object. | |||||||||||
IMPORTANT: The TV set is designed to operate on | • Do not place the remote control under the direct | ||||||||||
| sunlight or near sources of excessive heat. | ||||||||||
• After unpacking, allow the TV set to reach the ambi- | Note: Remove the battery from remote control hand- | ||||||||||
ent room temperature before you connect the set to |
| set when it is not to be used for a long period. | |||||||||
the mains. |
| Otherwise it can be damaged due to any leak- | |||||||||
Connections To The Aerial Input Socket |
| age of battery. | |||||||||
• Connect the aerial or cable TV plug to the Aerial input | Operating Range for the Remote Control | ||||||||||
socket located at the rear of the TV and connect the | • Point the top of the remote control toward the LCD | ||||||||||
cable plug coming out from the TV out socket lo- | TV's remote sensor LED while pressing a button. | ||||||||||
cated on the devices (VCR, DVB etc.) to this socket |
|
|
| ||||||||
as well. |
|
|
|
Inserting Batteries In The Remote
Control Handset
WARNING : Remote control is battery included.A plas- tic protector is used to disconnect the batteries in order to prevent the battery life from reducing. Please remove the plastic protector before the first use.
• Remove the battery cover located on the back of the handset by gently pulling backwards from the indi- cated part.
• Insert two AA/R6 or equivalent type batteries inside. |
|
|
|
Place the batteries in the right directions and replace | 30 |
| 30 |
the battery cover. |
|
|
|
|
|
| |
|
|
|
|
| |||
|
|
|
|
| |||
|
|
|
|
| |||
|
|
| |
|
|
|
|
|
|
| |
|
|
|
|
|
|
| |
|
|
|
|
Remote Control range is approx 7m/23ft.
Downloaded From