Connecting the antennas
Both AM and FM indoor antennas are included with this unit. In general, these antennas should provide sufficient signal strength. Connect each antenna correctly to the designated terminals.
| AM loop antenna | Indoor FM antenna | |||||
| (included) | (included) | |||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
TUNER
AM
ANT
GND
75Ω UNBAL.
FM
ANT
Ground (GND terminal)
For maximum safety and minimum interference, connect the antenna GND terminal to a good earth ground. A good earth ground is a metal stake driven into moist earth.
CONNECTIONS
Notes
•The AM loop antenna should be placed away from this unit.
•The AM loop antenna should always be connected, even if an outdoor AM antenna is connected to this unit.
•A properly installed outdoor antenna provides clearer reception than an indoor one. If you experience poor reception quality, an outdoor antenna may improve the quality. Consult the nearest authorized YAMAHA dealer or service center about outdoor antennas.
■ |
| PREPARATION |
| ||
| (U.K. model only) |
|
1 | Open the cover of the |
|
| included |
|
| antenna adapter. |
|
2Cut the external sleeve
of the | 11 mm | |
8 mm | ||
|
cable and prepare it for 6 mm connection.
3Cut the lead wire and
remove it. | Lead wire |
■Connecting the AM loop antenna
4 | Insert the cable | |
1 Set up the AM loop antenna, then connect it |
| wire into the slot, |
to the terminals on this unit. | and clamp it with | |
|
| pliers. |
ClampClamp
Insert wire into 
slot.
5Snap the cover into place.
■FREQUENCY STEP switch
(Asia and General models only)
2 Press and hold the tab to insert |
the AM loop antenna lead wires |
into the AM ANT and GND |
Because the interstation frequency spacing differs in different areas, set the FREQUENCY STEP switch (locating on the rear panel) according to the frequency spacing in your area.
AM FM
terminals. |
3 Orient the AM loop antenna |
for the best reception. |
•North, Central and South America: 100 kHz/10 kHz
•Other areas: 50 kHz/9 kHz
Before setting this switch, disconnect this unit’s power cord from the AC wall outlet.
English
19
