WATCHING TV
Sleep Timer can be set the unit to go to the standby mode after an incremental period of time.
Press SLEEP repeatedly to change the amount of time (increases |
|
|
|
Sleep | 120min. |
| |
the time by 30 minutes up to 120 minutes). |
| ||
|
|
|
Press SLEEP once to call up the display for checking the remaining time.
•To cancel sleep timer, press SLEEP repeatedly until
[Sleep Off] is displayed.
Switching Each Input Mode can easily switch with the remote control between TV (ATSC or NTSC) and external devices when they are connected to the unit.
Press SOURCE or CH + repeatedly to cycle through the input modes.
Source
TV
Video1
Video2
Component
HDMI1
HDMI2
HDMI3
e.g.)
11.1 | Video1 | Video2 | Component |
DTV/TV channel
HDMI3 |
| HDMI2 |
| HDMI1 |
|
|
|
|
|
(or PC input)
• Pressing CH − reverses the direction of the input modes.
Freeze Mode can freeze the image shown on the TV screen for 5 minutes.
Press FREEZE to freeze the image.
Freeze
•The sound output will not be paused.
•To cancel freeze mode, press any buttons except 
.
Channel Selection
Select channels by using CH + / − or the Number buttons.
•To select the memorized channels, use CH + / − or the Number buttons.
•To select the non-memorized channels,
use the Number buttons. | 11.1 |
|
|
To use the Number buttons
ATSC .
- When selecting digital channel 11.1
Be sure to press before entering the subchannel number.
NTSC
-When selecting cable or analog channel 11
Press PREV CH to return to the previously viewed channel.
Note | • | [No Signal] will appear on the TV screen after the subchannel broadcast is over. |
| • | [Audio only program] message will appear on the TV screen, when you receive |
|
| only sound signal. |
16
EN