Magnavox 46MF401B Preparation, Antenna Connection, Connection to Cable Receiver or, Satellite Box

Page 9

PREPARATION

No supplied cables are used with these connections:

Please purchase the necessary cables at your local store.

Use an HDMI cable with the HDMI logo (a certified HDMI cable). High Speed HDMI cable (also known as HDMI category 2 cable) is recommended for the better compatibility.

Before you connect:

Be sure your antenna or other device is connected properly before plugging in the AC power cord.

Antenna Connection

Connect the RF coaxial cable on your home outlet to the antenna input jack of this unit.

e.g.)

VHF / UHF analog

or DTV antenna

RF coaxial cable

or

cable TV signal

rear of this unit

Once connections are completed, turn on the unit and begin initial setup. Channel scanning is necessary for the unit to memorize all available channels in your area. [Initial Setup] p.15

Note

If you have any question about the DTV’s antenna, visit www.antennaweb. org for further information.

Depending on your antenna system, you may need different types of combiners (mixers) or separators (splitters). Contact your local electronics store for these items.

For your safety and to avoid damage to this unit, please unplug the RF coaxial cable from the antenna input jack before moving the unit.

If you did use an antenna to receive analog TV, it should also work for DTV reception. Outdoor or attic antennas will be more effective than a set top or inside antenna.

To switch your reception source easily between antenna and cable, install an antenna selector.

If you are not receiving a signal from your cable service, contact the Cable provider.

English

 

Connection to Cable Receiver or

INTRODUCTION

Satellite Box

 

Use an HDMI or component video cables to connect the

 

HDMI or the Component Video Input jacks of the unit to

 

the HDMI or the component video output jacks of the cable

 

receiver / satellite box.

 

If you connect to the unit’s Component Video Input jacks,

PREPARATION

satellite dish

connect audio cables to the Audio L/R Input jacks right beside

 

the Component Video connector.

 

e.g.)

 

or

RF coaxial cable

WATCHINGTV

ANT IN

cable TV signal

cable receiver /

 

 

 

 

 

including PPV

 

 

STEREO

 

 

satellite box

 

 

PCM

 

OPTIONAL

HDMI OUT

or

AUDIO OUT

COMPONENT VIDEO OUT

 

L

R

Y

Pb/Cb

Pr/Cr

 

 

 

SETTING

 

 

 

 

(green)

(blue)

(red)

 

 

 

 

 

 

HDMI cable

 

 

 

 

 

TROUBLESHOOTING

 

or

component video cables

 

(red / blue / green) and audio

 

 

 

 

 

 

cables

 

 

 

 

 

 

 

or

INFORMATION

side or rear of

 

 

 

 

 

 

this unit

 

 

 

 

 

 

 

You can also connect this unit to the cable receiver or satellite box other than the HDMI or the component video output jacks because they might have different output jacks.

Required cables and connecting methods of the cable receiver / satellite box, or the availability channel for the clear QAM may differ depending on the cable / satellite provider. For more information, please contact your cable / satellite provider.

9

EN

Image 9
Contents Necesita ayuda Inmediata? 46MF401BFor Customer Use Dear Magnavox product ownerStability properties of its cabinet design Read before operating equipmentResponsible Party Funai CORPORATION, Inc Trademark InformationTrade Name Magnavox Model 46MF401BContents FeaturesIntroduction Symbols Used in this Manual Supplied AccessoriesAttaching the Base Fixing the Unit on Your FurnitureTerminals Control PanelSide Panel Rear PanelInstalling the Batteries Remote Control FunctionAntenna Connection PreparationConnection to Cable Receiver or Satellite BoxExternal Device Connection Hdmi connection offers the highest picture qualityFor Hdmi connection Component video cables BD/DVD recorder with Component video output jackVideo CableCamcorder Audio cables Side of this unitStereo system 640 480 Resolution800 600 024 768Rear of this unit AC power cord AC outlet Plug In the AC Power CordCable Management Below. MP3/JPEG Playback p.31Initial Setup When selecting cable or analog channel Select channels by using CH + / − or the Number buttonsWatching TV To select the non-memorized channels Use the Number buttonsPress Mute again or VOL + / − to recover Original volume Use VOL + / − to adjust the volumeEdges of the screen Movie Expand displays a 169 picture that isReducing the Brightness TV Screen InformationFun-Link Options Program title Program guideMain Menu Optional SettingAdd Channels Channel ListLanguage Selection Antenna ConfirmationLanguage Use / to select Language, then press OKSound Adjustment Picture AdjustmentAdjust the following items Smart PictureSmart Sound Auto Volume LevelingEqualizer Virtual Surround SoundThere are 3 display modes according to programs Closed CaptionCS-1 to CS-6 Font opacity of the displayed caption can be switched as IllustratedClosed Captioning font style can be changed as illustrated Use / to select the desired rating, then press OK Child LockUS Movie ratings lock is the rating system created by Mpaa Use / to select US Movie Ratings Lock, then pressTV-14 Unsuitable for children under Mature audience onlyGeneral audience TV-Y7 Appropriate for all children 7 Older Appropriate for all childrenFun-Link Energy Saving Mode LocationCurrent Software Info Music MP3 / Jpeg PlaybackPicture DetailTroubleshooting Guide TroubleshootingScreen Volume changesNoise or trash ChangeMy remote control does not IR Signal Check p.35 Work Check the batteries of the remote controlRemote control signal of this unit Why I cannot watch some RFMaintenance InformationGlossary General Specifications Electrical SpecificationOther Specifications Shipping charges to return defective product Can be providedContact the Customer Care Center at