Magnavox TB100MG9 Front Panel, Remote control sensor Power indicator, Rear Panel, ANT. OUT jack

Page 9

Front Panel

Panel frontal

Before Using

1 2

1Remote control sensor

2 POWER indicator:

Turns green when the STB is in operation.

Se vuelve verde cuando el STB está en operación.

Rear Panel

Panel trasero

1AC power cord

2AUDIO OUT jacks (Right-red / Left-white): Connect your TV, stereo system or VCR etc. with standard audio cables.

Conecte su TV, sistema estéreo o VCR, etc., con cables de audio estándares.

3VIDEO OUT jack (yellow):

Connect your TV or VCR etc. with a standard video cable.

Conecte su TV o VCR, etc., con un cable estándar de video.

4 5

4ANT. IN jack: Connect an antenna.

Conecte una antena.

5ANT. OUT jack:

Connect to the ANT. IN jack on your TV.

Conecte a la toma ANT. IN de su TV.

Image 9

Contents TB100MG9 Risk of Electric Shock Do not Open Before UsingInsert Important Copyright Information PrecautionsB l e o f C o n t e n t s Before Using Advanced OperationOverview Accessories Installing BatteriesInformation on Digital Broadcasting Location of Controls Remote ControlFront Panel Remote control sensor Power indicatorRear Panel Video OUT jack yellowConnecting to a TV with A/V Jacks Connecting to a TV without A/V JacksConnections White red YellowWhite Connecting to a Cable Box OptionalRed EllowRed yellow Connecting to Other DevicesInitial Setup Initial Setup Setup WizardPress STANDBY-ON on the remote control to activate the STB Appropriate Viewing ChannelSelect the language using K / L, then press OK Select Continue using s / B, then press OKSelect your time zone using K / L, then press OK Select Autoscan using K / L, then press OKSelecting Channels on the STB Basic OperationAbout Sub-channel Broadcasting Enter the main channel numberPress Audio repeatedly To cancel still modePress Still Choosing Audio LanguagePress Display Select the desired program using s / BPress EPG while watching TV Channel BannerSelect ADD/ Delete using K / L, then press OK Press SetupAdvanced Operation Autoscan Receiving ChannelsSelect Delete using K / L, then press OK Press Setup to exitPress OK again to add the channel to the channel map AddSelecting Display Mode Adjusting AntennaPress Setup Select Detail using K / L, then press OK SelectDISPLAY MODEusing K / L, then press OKSetting the Time Zone and D.S.T Daylight Saving Time Information on Display ModePress Setup Select Time using K / L , then press OK Select Time Zone using K / L , then press OKSelect on or OFF using s / B , then press OK Select D.S.T using K / L , then press OKEnter the password using the Number buttons Chip OptionsSelect the desired rating using Select the desired rating type using K / L , then press OKThen press OK repeatedly to switch between view and block Mpaa RatingEnter the new 4-digit password using the Number buttons Select NEW Password using K / L , then press OKSelect Manual using K / L , then press OK Press Setup Select Detail using K / L , then press OKSelect Closed Caption using K / L , then press OK Closed Caption OptionsSelect desired amount of time using K / L , then press OK Auto Power DownMethod 1 Método Viewing Analog TVSelect CH3 in RF OUT menu Select ch3 on your TVSelect RF Through in RF OUT Method 2 MétodoSelect the desired channel on your TV Press STANDBY-ON to activate the STBUsing Setup to Switch RF OUT Setting Setting RF OUTSelect RF OUT using K / L, then press OK Select the desired setting using K / L, then press OKOthers TroubleshootingSpecifications Customer Service Tel Limited Warranty