Fostex D-108 Using two current drives, Press the Disp SEL key twice to enter Setup mode

D-108 Quick Operation Guide

Using two current drives

In addition to using an E-IDE hard disk or a SCSI drive as the sole current drive, you may also use an E-IDE hard disk installed in the D-108 along with a SCSI drive connected to the unit. To format these two current drives, follow the steps below.

When you turn on the power to all the devices, usually the E-IDE hard disk will start up as the current drive. Therefore, you will first format the E-IDE hard disk, then use the [Disk Format?] menu in the SETUP menu to format the SCSI disk.

These instructions assume that you have finished formatting the E-IDE hard disk according to the procedure described on page 8 and that now you are going to format the SCSI drive disk. Currently, the display indicates the top of Program 1 (ABS 0) which was created after the hard disk format operation.

SCSI drive as a current drive

8TRACK DIGITAL RECORDER D-108

POWER

E-IDE hard disk

1. Press the DISP SEL key twice to enter SETUP mode.

								ABS																	SETUP
																	REMAIN
OL									OL									OL
0									0									0
3									3									3
6								44.1kHz	6								44.1kHz	6							44.1kHz
9									9									9
12									12									12
18									18									18
24									24									24
30									30									30
42									42									42
∞									∞									∞
1	2	3	4	5	6	7	8		1	2	3	4	5	6	7	8		1	2	3	4	5	6	7	8

Usual Time Base display REMAIN display SETUP mode display

2. Press the EXECUTE/YES key.

The D-108 enters SETUP mode and displays the SETUP mode menu used prior to shut down.

With the default setting, [Drive Sel.?] menu appears.

OL

0

3

6

9

12

18

24

30

42

∞

1 2 3 4 5 6 7 8

SETUP

44.1kHz

3. Turn the JOG dial to select the [Disk Format?] menu and press the EXECUTE/YES key.

[IDE] flashes, indicating the IDE disk is currently selected.

SETUP

OL								FORMAT	OL
0									0
3									3
6									6
9								44.1kHz	9
12									12
18									18
24									24
30									30
42									42
∞									∞
1	2	3	4	5	6	7	8		1	2	3	4	5	6	7	8

SETUP

FORMAT

44.1kHz

4. Turn the JOG dial clockwise to change [IDE] to [SCSI#] and press the EXECUTE/YES key.

[No SCSI Disk!] appears momentarily, then a flashing [SCSI #] appears.

								SETUP																	SETUP
OL								FORMAT	OL									OL							FORMAT
0									0									0
3									3									3
6									6									6							44.1kHz
9								44.1kHz	9								44.1kHz	9
12									12									12
18									18									18
24									24									24
30									30									30
42									42									42
∞									∞									∞
1	2	3	4	5	6	7	8		1	2	3	4	5	6	7	8		1	2	3	4	5	6	7	8

15