Dynex DX-L321-10A manual Troubleshooting, Restoring default settings, To restore default settings

DX-L321-10A_09-0407_MAN_ENG_V3.book Page 22 Wednesday, May 13, 2009 11:38 AM

22 Troubleshooting

4Press or to select the input source you want to assign a label to, then press ENTER. The Custom Input Label screen for that input source opens.

5Press , , , or to select a label for the input source, then press ENTER to apply the new label.

6Repeated Steps 3–5 to apply labels to other input sources. These labels are displayed when you press INPUT or any of the individual input source keys.

Note: If you have forgotten your PIN, the default number is 9999.

5Press or to select Yes, then press ENTER to load the default menu settings.

After the system reset the Welcome prompt appears. Perform a channel scan to reload the channels to your TV and then access the on-screen menus to reconfigure the TV settings.

Restoring default settings

Caution: When you restore default settings, all the settings (except the password and parental rating) you have customized are reset.

To restore default settings:

1Press MENU on the remote control, or MENU on the control panel of your TV. The on-screen menu bar opens.

2Press or to highlight Settings, then press ENTER. The Settings menu opens.

3Press or to highlight Reset All, then press ENTER. You are asked for your PIN.

4Enter your PIN number. A confirmation box opens.

Troubleshooting

Warning: Do not try to repair your TV yourself. Contact authorized service
personnel.
Problem	Solution
No power	• Make sure that the power indicator is
	illuminated blue.
	• Make sure that the power cord is securely
	connected to the AC-in jack and is plugged
	into a functional AC outlet. You may want to
	plug in another electrical device to the
	power outlet to verify that it is supplying
	the proper voltage.
Power is suddenly	Press MENU and select Settings, Sleep Timer
turned off	to make sure the Leave TV Off option is
	selected.
Your PIN is	1. Press MENU and select Settings, Reset All,
compromised	and then Yes.
	2. Access the on-screen menu again and select
	Locks.
	3. Key in and reconfirm your new PIN.
Remote control	• Replace the batteries. For more
does not work	information, see “Installing remote control
	batteries” on page 6.
	• Make sure that the batteries are inserted
	correctly. For more information, see
	“Installing remote control batteries” on
	page 6.
	• Make sure that the power cord is plugged
	into an AC power outlet.
The remote control	• Purchase a separate learning remote
code cannot be	control.
detected by a	• Go to www.dynexproducts.com for a list of
universal remote	remote control codes.