Bosch Appliances 715ES Remote control, Activation, To determine, Version in the water heater

Remote control installation

4.2	Remote control				B On heater control panel press and
	activation				hold	Program key		or
					while turning on the power switch (I).
i	Before	the		remote	Release program key			when	LCD
	control will work, it must				displays “188”.
	be activated using the				LCD shows “P2”. If not, repeat
	procedure		described		previous step.
	below with the operator				B Select “P3” using buttons				and
	standing in		front	of the
						on heater.
	appliance.
					B Press and hold Program key
The	remote	control		activation	or	again for 1 sec.
					LCD shows one number and one
instructions vary based on the version
of control board installed in your					rotating digit. If not, repeat previous
heater.					step.
To determine		the	control board		The number		represents	the remote
					control which is to be registered, the
version in the water heater:
					first remote control will be registered
B Turn power switch on the water					with number “0”, the second with
heater to the off position (O).					number “1” and so on.
B When turning power switch to the					The rotating		digit shows that		the
					electronics is expecting a registration.
on position, note the first two letters
					If the LCD fails to show a number and
that appear on the display (should
					rotating digit after repeated attempts,
be AF or SU).
					double	check	the wire	connections
B If the letters are AF, follow
					made in section 4.1.
section 4.2.1.
					B Hold remote control in front of the
For SU, follow section 4.2.2.
					control panel on the heater and
4.2.1	AF board
					simultaneously press remote control
B Connect power to heater.					buttons		and	until	the
					temperature indication is shown on
B Move the power			switch on the
					the remote control LCD.
appliance to the off position (0).

8 6 720 606 990