Front Panel
LCD control panel: Use the control panel buttons to navigate through the various functions viewed on the LCD display.
Figure 3. LCD Control Panel
The DVD Duplicator control panel features an LCD display and two buttons. These buttons are described in the following table:
In Operation mode, press the SET button to scroll up through the functions or menus.
In Operation mode, press the RUN button to execute the selected function.
target drives: Insert a blank disc into each target drive to make a copy of the source disc. You can open the tray by pressing the eject button (if the tray fails to open, you can use the emergency eject mechanism). You can close the tray by pressing the eject button.
Note: TEAC strongly recommends that you do not push the tray in to close it. Please press the eject button to eject or retract the tray.
LED power indicator: The LED power indicator will be continuously lit when the DVD Duplicator power is on.
power switch: Use the power switch to turn the power to the DVD Duplicator unit on and off.
stabilizing feet: A stabilizing support foot is located at each of the DVD Duplicator’s lower four corners. When you set up the Duplicator, you should extend each of these feet outward to provide stable support for the unit.
4 | TEAC 1x10 DVD Duplicator User’s Manual |