Setup Mode Functions
Setup Mode Functions
The Setup mode includes nine (9) functions. To enter the Setup mode, press and hold the SET button until you hear a beep. The LCD will then display SETUP. Press the SET button to scroll through the available functions. To exit the Setup mode, press and hold the SET button until you hear a beep. Each function is explained below.
Automatic
This function is for factory use only.
Partition Name
The Partition Name function enables you to setup the ID and partition number of the hard disk drive.
The first two (2) digits are the ID number of the hard disk drive. This ID can range from 00 to 99. The remaining three (3) digits represent the position of the partition. The default setting is 00000.
Set as Default
This function allows you to set any changes or modification you have made as your default settings.
Update Firmware
The Update Firmware function updates the firmware on the interface board via a CD or DVD disc. The DVD Duplicator will locate the data and update its firmware automatically.
During the update, do not turn off the power to the unit. Once the update is complete, the LCD will display a message and all arguments will return to the default setting. Please restart the system to complete the firmware update procedure.
CD Reading Speed
The CD Reading Speed function controls the speed at which the source drive reads a
The default setting is MX (maximum) read speed.
❑RUN: Modify parameter.
❑SET: Save and quit.
TEAC 1x10 DVD Duplicator User’s Manual | 13 |