Teac DVW-D110H user manual DVD Duplicator Functions, Operation Mode Functions

Page 19

Operation Mode Functions

Chapter 3. DVD Duplicator Functions

The DVD Duplicator features three (3) modes of operation:

Operation mode

Setup mode

Advanced mode

Operation Mode Functions

Operation mode includes seven (7) functions. Each function is explained below.

Test

The Test function simulates writing to the target disc. The discs will remain blank after the test is complete. This function is recommended if you are using unsupported media. This function enables the target drive to adjust the laser to the proper intensity. The source drive, which is determined by the setting on the Duplicator controller, can be either the DVD-ROM drive or the hard disk drive.

Copy

The Copy function enables you to copy data from the source DVD or a partition on the internal hard disk drive. For more information, refer to “Basic Operation” on page 8.

Compare

The Compare function compares data on the source and target discs after the copy process is complete.

Copy and Compare

The Compare function follows immediately as soon as the Copy function is completed.

Verify

The Verify function verifies that the target disc was written completely and with no errors.

TEAC 1x10 DVD Duplicator User’s Manual

11

Image 19
Contents DVW-D110H Page Copyright and Trademark Information Safety PrecautionsPiracy Statement Introduction About This ManualTable of Contents Appendix A. List of Functions List of Figures Teac 1x10 DVD Duplicator User’s Manual Introduction DVD Duplicator Package Contents Illustrates the front panel of the DVD Duplicator unit Front PanelLCD Control Panel Illustrates the rear panel of the DVD Duplicator unit Rear PanelRear Panel Setup Using the DVD DuplicatorCopying from the Optical DVD Source Drive Basic OperationInsert a source DVD into the DVD-ROM drive Loading Data to and Copying from the Hard Disk Source DriveLoading Data to and Copying from the Hard Disk Source Drive DVD Duplicator Functions Operation Mode FunctionsLoad EraseSetup Mode Functions DVD Writing Speed Advanced SetupCD Writing Speed DVD Reading SpeedSkip Read Err Advanced Mode FunctionsChoose Source Disc CounterShow Disc Info CD Writing WayDVD Writing Way Check TRK LENSupport UPC/ISRC Enable Send OPCShow Exe. Time Auto Exe. TimeCD Gigarec Rate Disable LO ChangeBoot Delay Time Partition SizeAppendix A. List of Functions Error Code Definition Appendix B. LCD Error Code DefinitionsHandling Discs Appendix C. About DVD and CD DiscsEjecting the Disc Tray Loading and Ejecting DiscsDVW-D110H Appendix D. SpecificationsLimited Warranty Appendix E. Technical Support and WarrantyExclusion of Damages Limited Warranty