Runco XP-50DHD, XP-103DHD, XP-OPAL65DHD, XP-OPAL50DHD operation manual Information, Signal, System

Page 64

Information ➤

Information

Signal

System

Field Service

Manufacturing

To save the settings for the current input and display mode to the

Note ISF Night or ISF Day memory preset, select Save ISF Night or Save ISF Day from the Calibration menu (refer to Save ISF Night/Save ISF Day on page 51).

To reset the Custom 1 or Custom 2/THX memory preset to its factory-default state, select it, press or to highlight Reset and press ENTER.

Signal / System: Select Information from the Main Menu, then choose either Signal or System to display information about the current input signal (resolution, frequency, type et cetera) and installed firmware versions, as well as other information that uniquely identifies your DHD Controller and display device.

Should you ever need to contact Runco Technical Support, this information will help them answer your questions or resolve product performance issues.

Signal

 

Input Source

HDMI 1

Signal Format

1080p/60

Input Resolution

1920x1080

Vertical Freq

59.94 Hz

Horizontal Freq

67.500 kHz

Pixel Clock

148.500 MHz

Color Space

REC709

Sync Type

Separate

Memory Preset

ISF Night

 

 

System

Model

DHD3

Display Name

XP-50DHD

Output Resolution

1920x1080

Serial Number

00000000

Boot Version

3.0

Firmware Version

3.4

Micro Version

3.3

 

 

Field Service / Manufacturing: The Field Service and Manufacturing menus are password-protected and intended for use only by Runco service personnel and factory technicians.

48

PlasmaWall XP Series Installation/Operation Manual

Page 63 Page 65
Image 64
Page 63 Page 65
Contents XP-50DHD XP-OPAL50DHD XP-65DHD XP-OPAL65DHD XP-103DHD Page RuncoCare Standard Two Year Limited Warranty RuncoCare Standard FeaturesRuncoCare Claim Procedure Page Copyright and Trademarks Important Safety Instructions Compliance Information Declaration of ConformityFCC Part Page Table of Contents Maintenance and Troubleshooting OperationSpecifications External ControlTable of Contents Xiv List of Figures PlasmaWall Model XP-65DHD and XP-OPAL65DHD Dimensions Introduction About This ManualUsing This Manual If you need Turn toDescription, Features and Benefits Key Features and BenefitsOptional Accessories XP-50DHD and XP-OPAL50DHD Controls and Functions Controls and IndicatorsPlasmaWall at a Glance Power Button STANDBY/ON IndicatorRemote Control Sensor Display StandShows the rear-panel connector locations on the PlasmaWall ConnectorsDHD Controller Front Panel Left Button Down ButtonRight Button Menu ButtonOutputs 1. Hdmi Out DHD Controller Rear PanelTriggers Inputs Main Power SwitchMain AC Fuse PlasmaWall Remote Control Unit DHD Controller/PlasmaWall Remote ControlIR Output Indicator EnterReturn / Exit LightCinema SVCISF Night ISF DAYInstallation Remote ControlInstallation Overview Quick SetupStep Procedure For Details, refer to Installation Considerations Ambient Light VentilationVentilation Requirements for Enclosure Mounting XP-103DHD Synchronization Issues Possible Audio Latency for Various Input/Output TimingsAudio/Video Input Timing Possible Audio Latency millisecondsOther Considerations Connections to the PlasmaWall and DHD Controller Connecting PlasmaWall to the DHD ControllerPlasmaWall Rear Panel RS-232 Connection from the DHD Controller to the PlasmaWall Components to the DHD Connecting SourceController BD/DVD DTV-STB DTV-Set-Top BoxComputer RGB CamcorderVCR DVD/DTV STB10. S-Video and Composite Video Source Connections RS-232 Controller ConnectionConnecting 12-volt 12. Connecting 12-volt Trigger OutputsConnecting an External IR Receiver to the DHD Controller 13. External IR Receiver Connection14. AC Power Connection Turning on the Power Setting the Computer Display Properties OperationOperation Using the On-Screen Menus Input PositionMain Menu Runco VideoInput Source Aspect RatioInput Source Aspect RatioAspect Ratio Settings Remote Aspect Ratio Control Description Button 169Select 169 to view 169 DVDs Hdtv programs in theirRemote Aspect Ratio Control Description Button OverscanPicture PictureTypical Gray Bar Pattern for Adjusting Contrast Gray Yellow Cyan Green Magenta Red Blue Gray Yellow Cyan Green Magenta Red Blue Typical Test Pattern for Adjusting Sharpness Input Position Input PositionAdjust the Phase after adjusting Tracking see below Memory Presets Memory PresetsSignal InformationInformation SystemCalibration ISF Settings CalibrationColor Temperature Presets and Associated Color Points Color Temperature Preset Associated x/y ValuesOperation Copied settings are not retained after a power cycle Copy/PasteService ServiceInput Names Exit Operation LCD 47 and ISF Day/Night Memory Presets Operation Maintenance and Troubleshooting CleaningCleaning the Display Panel Body and Remote Control Cleaning the ScreenTroubleshooting Chart Troubleshooting TipsSymptom Possible Causes Solution To Input Position on Maintenance and Troubleshooting Port Configuration Serial Command SyntaxExternal Control Serial CommunicationsSerial Commands Input Selection CommandsPicture Adjust Commands Input Position Commands Output Shift CommandsEnter key Exit Return keyCommand Bits Using Discrete IR CodesWith Toggle Bit = Hex Binary Function Start IR Command List Remote Control With Toggle Description Button Name Bit =RC5 Control Codes for the DHD Controller RC5 DataEnter Specifications PlasmaWall SpecificationsPlasmaWall Specifications XP-OPAL65DHD100 to 240 VAC, 50/60HzDHD Controller Specifications DHD Controller SpecificationsDimensions PlasmaWallIR Receiver PlasmaWall Model XP-103DHD Dimensions with Floor Stand Supported Signal Timings by Input Format Resolution Frequency Rate Hz MHz KHzSupported Timings Supported? √ = Yes, = NoVideo 1 S-Video Format Resolution Frequency Component/ RgbhvVideo Rate Hz MHz KHzPAL-M Page 020-0726-03 rev. a September

XP-OPAL65DHD, XP-OPAL50DHD, XP-50DHD, XP-103DHD specifications

Runco, a pioneer in the field of high-end home theater projectors, has gained a reputation for producing top-tier models that deliver exceptional picture quality and advanced features. Among their notable offerings are the XP-50DHD, XP-OPAL65DHD, XP-OPAL50DHD, and XP-103DHD projectors. Each model showcases Runco's commitment to home cinema excellence through cutting-edge technologies and design.

The Runco XP-50DHD is recognized for its impressive 50-inch display, featuring a native 1080p resolution that ensures sharp and vivid images. This model employs Runco's proprietary InfiniLight technology, providing an intense contrast ratio and remarkable black levels. With Faroudja DCDi Cinema processing, the XP-50DHD excels in scaling lower-resolution content to Full HD, enhancing the viewing experience by eliminating noise and artifacts.

The XP-OPAL65DHD takes performance a step further with a larger 65-inch display and an advanced color management system. This projector incorporates Runco's HDFury technology, allowing for dynamic color management and precise calibration. The result is stunningly accurate color reproduction, making it ideal for home theater enthusiasts who demand the best in color fidelity. Furthermore, the XP-OPAL65DHD supports a wide array of input formats, from traditional HD to 4K, making it versatile enough to handle various content types.

Similarly, the XP-OPAL50DHD offers a 50-inch screen but stands out with its ultra-high-performance optical design. Its advanced lens technology ensures minimal distortion and uniform brightness across the entire image. This model is tailored for those who appreciate both aesthetics and technology in their home setup, featuring a sleek design that seamlessly integrates into any environment.

Lastly, the XP-103DHD projector offers an impressive 103-inch screen size, catering to those who want to replicate a true cinema experience at home. This projector boasts an expansive color gamut and high dynamic range (HDR) capabilities, making it a top choice for cinephiles. With Runco's unique processing algorithms, the XP-103DHD delivers images that pop with vibrancy, depth, and clarity, providing an immersive viewing experience.

Overall, Runco's lineup of XP projectors, including the XP-50DHD, XP-OPAL65DHD, XP-OPAL50DHD, and XP-103DHD, coalesce state-of-the-art technologies and thoughtful design, positioning them as leaders in the luxury projector market. Whether it’s the size, color accuracy, or image processing capabilities, each model exemplifies Runco's dedication to enhancing home theater experiences for discerning users.
Top Page Image Contents