Runco PlasmaWall manual PL-50HDX Control Panel, STANDBY/ON Indicator

Page 12

PL-50HDX Control Panel

Plasma

Front View

1.STANDBY/ON Indicator

This indicator is red during standby mode, and turns green when the unit is in the operation mode. It flashes green when Power-Management function is operating. The flashing pattern is also used to indicate error messages.

2.Display Stand

3.Remote Control Sensor Not used.

Image 12

Contents PL-50HDX Page Contents Features and Benefits IntroductionAvertissement Safety Tips DOC compliance NoticeDOC avis de conformation Limited Warranty What is Covered Under the Terms of this Limited WarrantyRIGHTS, Limits and Exclusions Quick Setup Instructions General OverviewPL-50HDX Inputs and Controls Synchronizing signal impedance selector switch Main Power switchAudio Input Stereo mini jack Audio Output Stereo mini jackSTANDBY/ON Indicator PL-50HDX Control PanelPFP Controller Description Front PanelRear Panel Remote Control Description Power ButtonQuick Setup Guide Connecting the Plasma and PFP ControllerPlasma Bottom View ComLink Control Cable DVI Source Connection Examples VCRMenu Description and Navigation Installation Menu Picture Quality Adjustments White Yellow Cyan Green Magenta Red BluePage Side Bar Level ‘43 burn’System Reset To reset your PFP Controller, follow this procedureImage Shift Aspect Ratios Units tall Units wideActive image area Actual screen area Blanked cut off Areas RS-232 Communications Other notesRS-232 Commands PL-50HDX Plasma Dimensions PFP Controller Dimensions Top PanelSide Panel PL-50HDX Plasma Specifications PFP Controller Specifications Supplied AccessoriesInput standards BandwidthPage RUMA-009800 rev

Related manuals

Manual 2 pages 51.55 Kb