PFP Controller Description, Front Panel

PFP CONTROLLER DESCRIPTION

Front Panel

1 2

ratio

< enter

ratio

i n p u t

1.IR RECEIVER

Receives the IR commands from the remote control.

2.POWER BUTTON

Toggles the power on and off. For a discreet on or off command, you can use the direct access buttons on the remote control. NOTE: When the main AC power switch is first turned ON, the processor will go through an initiation cycle for approximately 15 seconds. The processor cannot be turned on or operated until the initialization is complete

3.LED DISPLAY

Indicates the model number, current source, scan rate or resolution and aspect ratio.

4.UP BUTTON

When no menus are present on-screen, the UP button will toggle you through aspect ratios in the following order:

VirtualWide Standard (4:3) Letterbox Anamorphic

When the menu is on-screen, the UP button will move the cursor up within the menu.

When an adjustment item has been selected (i.e. brightness), the UP button will increase the value of that function.

5.LEFT BUTTON

When no menu is present on-screen, the LEFT button will toggle you through the four different sources, in the order of:

DVI		RGBHD		Component HD		Component		S-Video		Composite

6.ENTER BUTTON

When an item is highlighted on the On-Screen Display, the ENTER button will select the item.

7.DOWN BUTTON

When the menu is on-screen, the down button will move the cursor down within a menu. When an adjustment function has been selected (i.e. brightness), the DOWN button will decrease the value of that function.

8.RIGHT BUTTON

When no menus are present on-screen, the RIGHT button will toggle you through the four different sources, in

the order of:	S-Video	Component	Component HD	RGBHD	DVI
Composite

9.MENU BUTTON

Pressing the MENU button will bring up the main menu. If no action is taken within approximately 10 seconds, the menu will time-out (disappear). Also, if you are in an adjustment mode or function, pressing MENU will bring the menu back one level.