Runco PlasmaWall, PL-50HDX manual Menu Description and Navigation

Page 18

MENU DESCRIPTION AND NAVIGATION

INPUT SELECT

STANDARD VIDEO:

>COMPOSITE S-VIDEO COMPONENT

HIGH DEFINITION:

COMPONENT

RGB

MONITOR INPUT:

DVI

ASPECT RATIO

INSTALLATION

When the MENU button is pressed on either the remote control or the front panel, the main menu will appear on-screen. An example of the main menu is shown above.

The active source is indicated by an arrow to the left of the source; note that in the example above, Composite is the current source.

To select a source via the main menu, press either the up or down buttons on the remote or front panel and highlight the desired source, and press ENTER. Otherwise, you may select a source by pressing either the left or right arrow buttons (on the remote or front panel) when no menus are on-screen, or by pressing one of the direct access buttons on the remote control (recommended; see page 15).

If HIGH DEFINITION is selected, note that no on-screen menus will be displayed since the signal is simply being 'looped' directly to the output. Pressing MENU will automatically revert to the last select- ed input. Pressing ENTER allows adjustments via Quick Menu Adjustments from front panel or VirtualWide.

ASPECT RATIO provides selection of one of four aspect ratios: Anamorphic, Letterbox, Standard 4:3 or VirtualWide. To select an aspect ratio via the main menu, press either the up and down buttons on the remote or front panel, highlight ASPECT RATIO and press ENTER. The aspect ratio menu will then appear with the three choices; highlight the desired aspect ratio with the up or down buttons and press ENTER. Otherwise, you may select an aspect ratio by pressing either the up or down arrow buttons (on the remote or front panel) when no menus are on-screen, or by pressing one of the direct access buttons on the remote control.

INSTALLATION is where 'side bar' levels can be adjusted, as well as image shift and blanking con- trols. A full description of this menu is on page 19.

NOTE: If INSTALLATION does not appear on the main menu, see page 19 for an explanation on how to access the Installation menu.

18

Image 18
Contents PL-50HDX Page Contents Features and Benefits IntroductionAvertissement Safety Tips DOC compliance NoticeDOC avis de conformation Limited Warranty What is Covered Under the Terms of this Limited WarrantyRIGHTS, Limits and Exclusions Quick Setup Instructions General OverviewPL-50HDX Inputs and Controls Audio Input Stereo mini jack Synchronizing signal impedance selector switchMain Power switch Audio Output Stereo mini jackSTANDBY/ON Indicator PL-50HDX Control PanelPFP Controller Description Front PanelRear Panel Remote Control Description Power ButtonQuick Setup Guide Connecting the Plasma and PFP ControllerPlasma Bottom View ComLink Control Cable DVI Source Connection Examples VCRMenu Description and Navigation Installation Menu Picture Quality Adjustments White Yellow Cyan Green Magenta Red BluePage Side Bar Level ‘43 burn’System Reset To reset your PFP Controller, follow this procedureImage Shift Aspect Ratios Units tall Units wideActive image area Actual screen area Blanked cut off Areas RS-232 Communications Other notesRS-232 Commands PL-50HDX Plasma Dimensions PFP Controller Dimensions Top PanelSide Panel PL-50HDX Plasma Specifications Input standards PFP Controller SpecificationsSupplied Accessories BandwidthPage RUMA-009800 rev
Related manuals
Manual 2 pages 51.55 Kb