Remote Control Description, Power Button

REMOTE CONTROL DESCRIPTION

A.IR OUTPUT INDICATOR

Illuminates when a button is pressed, indicating that an IR signal is being transmitted.

B.POWER BUTTON

Toggles the power on and off. For a discreet on or off command, you

can use the direct access buttons (see 'J'). Note: When the main AC

power switch is first turned ON, the processor will go through an initiationAB cycle for approximately 10 seconds. The processor cannot be turned on

or operated until the initialization is complete.

UP BUTTON

When no menus are present on-screen, the UP button will toggle you

through aspect ratios in the following order:

VirtualWide

Standard (4:3)

Letterbox

Anamorphic

When the menu is on-screen, the UP button will move the cursor up

within the menu. When an adjustment item has been selected

(i.e. brightness), the UP button will increase the value of that function.

LEFT BUTTON

When no menus are present on-screen, the LEFT button will toggle

you through the four different sources in the following order:

DVI

RGBHD

Component HD

Component

S-Video

Composite

E.DOWN BUTTON

When no menus are present on-screen, the DOWN button will toggle you through aspect ratios in the following order:

Anamorphic		Letterbox	Standard (4:3)	VirtualWide	OFF

When the menu is on-screen, the DOWN button will move the
					ON
cursor down	within the menu. When an adjustment item has been

selected (i.e. brightness), the DOWN button will decrease the value of that function.

F.RIGHT BUTTON

When no menus are present on-screen, the RIGHT button will toggle you through the four different sources in the following order:

Composite		S-Video		Component		Component HD		RGBHD		DVI

		PWR
I		I
N	M	N
P	M	P
U		U
T		T

1 2 3

4 5 6

7 8 9

RUNCO

G.MENU BUTTON

Pressing the MENU button will bring up the main menu. If no action is taken within approximately 10 seconds, the menu will time-out (disappear). Also, if you are in an adjustment mode or function, pressing MENU will bring the menu back one level.

H.ENTER BUTTON

When an item is highlighted on a menu, pressing ENTER will select that item.

I.PROGRAM BUTTON

Select corresponding code set in the installation menu. To reprogram the remote, press the PROGRAM button followed by 0,1,3.

Note: Pressing Enter after typing in the code is not necessary.

J.DIRECT ACCESS BUTTONS

These buttons will allow you to directly access an aspect ratio, source, or turn the unit on or off without having to go through any menus. These buttons are:

1:Selects COMPOSITE video

2:Selects S-video

3:Selects COMPONENT video

4:Selects COMPONENT HD

5:Selects RGBHD

6:Enables or Disables the Installation Menu (see page 18)

7:Selects the ANAMORPHIC aspect ratio

8:Selects the STANDARD (4:3) aspect ratio

9:Selects the LETTERBOX aspect ratio

0:Turns the processor ON.

OFF: Also known as the button left of '0', this turns the processor OFF.