Runco CR-26HD, CR-32HDi manual Operation, Turning on the Power, Changing the OSD Language

4. Operation

1.Turn on your source components.

2.Plug the female end of the power cord into the AC receptacle on the rear of the Crystal Series LCD Display (AC 100V ~ 240V).

3.Connect the other end to your AC power source.

4.Turn on the main power switch at the rear of the display (CR-32HDi only).

5.The power indicator lights red to indicate that the Crystal Series LCD Display is in “standby” mode.

4.1

Turning on the Power

6.Press the ON button on the remote control to turn on the display (or press the power button on the front of the display). The power indicator flashes for a few seconds, then lights solid green.

7.After a brief warm-up period (approximately 10 seconds), the Crystal Series LCD Display will display an image.

OFFON

1 2 3

4 5 6

7 8 9

100 0 -

	SOURCE		SLEEP
INPUT	INPUT	INPUT	TIMER
1	2	3	OFF

The Crystal Series LCD Display OSD language is initially set to English, but can also display the menus in French, Spanish, Portuguese or German. To change the OSD language:

1.Press MENU.

2.Select Setup from the Main Menu.

3.Select OSD Language from the Setup Menu.

4.Press or to highlight the desired language and press ENTER. The change takes effect immediately.

4.2

Changing the OSD Language

Runco CR-26HD/CR-32HDi Owner’s Operating Manual 23