Zenith L20V54S warranty Cloning Connections/Learning Setup

Cloning Connections/Learning Setup

Connections for the LT2002 Clone Programmer to Learn the L20V54S Master TV Setup.

Antenna or CATV

Ferrite Core (TDK, ZCAT 2035-0930)

Warning: Do not use LT2002
if a LodgeNet PPV card is
installed in TV or clone
programmer device will be		Clone Programmer
damaged.
	Master L20V54S

*Note: It is assumed that the L20V54S is connected to a signal source, the source selected is Antenna (RF) In, the signal is from an Analog channel, not a digital channel, all equipment is connected to power and turned on and the LT2002 Clone

Programmer main menu (THE CLONE HAS CONTROL OF THE TV) menu is displayed on the TV screen, the clone programmer LED is blinking the required heart beat pattern, see above and next page.

*Note: Once the clone is connected, do not touch the unit or otherwise disturb it or the MPI connections. Any disturbance while the clone is operating may disrupt the master setup transfer or copying etc.

Before you begin cloning...

•The Master L20V54S should be connected to a good, stable signal from an over-the-air antenna or cable service Analog channel and connected to power. (See above.)

•Teaching and Learning is only possible between identical model

devices. (However, the LT2002 Clone programmer can store up to 3 different ‘master’ setups.)

WARNING: Copying a blank or incorrect memory into a TV, STB or other device will cause the TV, STB or other device to operate erratically or become inoperable.

•Use an Installer’s remote to operate Learning and Teaching menus.

•Make sure that the batteries in the Clone programmer are fresh.

•If batteries are removed, the Clone Clock time will be lost.

•Decide if you want to set the time from the Clone programmer or copy the time to the Clone programmer; from a compatible TV which has the clock set to the current time.

•Setting the time and transferring it to the Clone or other device is a separate procedure.

•Follow the connection diagram above to connect the Clone to a Master L20V54S TV display panel. After learning is complete, to another identical L20V54S TV display panel to “teach” it the master setup.

•After the L20V54Ss setup has been copied to another identical L20V54S, that identical unit with the copied setup, needs to be disconnected from power for about 15 seconds to activate the newly-copied setup.

•See the Clone Troubleshooting section to resolve problems.

Turn to the next page to continue Cloning Setup.

P A G E 4 2