LT2000 QuickSet Programmer
Use the Zenith LT2000 QuickSet II “Clone” Programmer to copy the setup from a “master” TV then quickly transfer the setup to duplicate TVs must be the same model number as the master TV.
Learn Master TV
Typical MPI Connections
THE CLONE HAS CONTROL OF THE TV
THE CLONE IS VERSION | XX |
THE TV IS VERSION | XX |
THE SW IS REVISION | XX |
CLONE CLOCK | = XX:XX |
TV CLOCK | = XX:XX |
| |
|
Teach Other TV
Typical MPI Connections
Antenna |
TV Back | TV Back |
| Antenna |
ANTENNA
CABLE | TV SPEAKER |
|
|
|
|
| |
RF Coaxial Wire |
|
| VIDEO IN SPEAKER OUT |
M.P.I. | PILLOW SPEAKER |
| |
(75ohm) |
|
|
|
|
|
| AUDIO IN |
TV Back Panel |
|
| |
(Expanded View) |
|
| |
| Connect cable to |
|
|
| TV MPI Jack and | Status | |
| follow | ||
| instructions | Indicator | |
| MPI |
|
|
|
|
| Reset |
|
| Color | |
|
| green | battery OK |
|
| red | battery low |
|
| Blink pattern | |
|
| slow | power on |
|
|
| no communications |
|
| heart beat power on | |
|
|
| communications OK |
| QuickSet II Programmer | ||
|
| LT2000 |
|
| ZENITH ELECTRONICS CORPORATION, GLENVIEW, ILLINOIS USA | ||
Clone
ANTENNA
CABLE | TV SPEAKER |
|
|
| |
RF Coaxial Wire |
| VIDEO IN SPEAKER OUT |
M.P.I. | PILLOW SPEAKER |
|
(75ohm) |
|
|
|
| AUDIO IN |
TV Back Panel |
| |
(Expanded View) |
| |
Connect cable to |
|
|
TV MPI Jack and | Status | |
follow | ||
instructions | Indicator | |
| MPI |
|
|
| Reset |
| Color | |
| green | battery OK |
| red | battery low |
| Blink pattern | |
| slow | power on |
|
| no communications |
| heart beat power on | |
|
| communications OK |
QuickSet II Programmer | ||
| LT2000 |
|
ZENITH ELECTRONICS CORPORATION, GLENVIEW, ILLINOIS USA | ||
Clone
The optional QuickSet II Clone Programmer (LT2000) allows custom setup and programming information to be quickly copied from a master TV into multiple identical television sets. Once learned from the master, setup data is retained in the LT2000 for future use.
When using the LT2000, cloning operations will go easier if the TV set is connected to a good quality signal and operating with a stable picture displayed. To operate the LT2000, use the indicated keys on an HP602, LP702, or MBR3447 remote, or the front panel keys on the TV receiver.
Page 39