Zenith HW20H52DT, H20H52DT warranty Table of Contents

TABLE OF CONTENTS

Use the steps outlined below as a setup guide and to determine the TV features that will require adjustment for the needs of the end user.

Safety Warnings	2
Important Safety Instructions	3 - 4
Table of Contents	5
Step 1. Hook Up the HealthViewTV
TV and other Equipment Hookups
Antenna	6
Cable Service	7
Antenna with VCR	8
Cable service with VCR	9
External Speaker Connection (8-ohm output)	9
Pillow Speaker	10
Step 2. Channel Search and Reception Setup
Auto Program	11
(Select Antenna, or cable service then do
channel search)
Front Panel Controls	12
Optional Installer’s Remote Key Functions	13
On-Screen Menus Overview	14
Step 3. Customize the TV’s Features

Setup Menu (Start with page 11, Auto Program)

Descriptions of the menus on the TV	15
Setting Add/Del/Blank	16
Clock Set	18

Setting On/Off Timers	17
Captions (Caption/Text)	19
Language	21
Video Menu	22
FM Radio Menus	23 - 24
Installer Parental Control Menu	25 - 26
Other Menus and On-Screen Displays	27
Managing the Channel Banks	28 - 30
Installer Menus	31 - 38
LT2000 Quickset II Clone Programmer	39 - 43

Patient Operation Section (Copy for patient usage)

Optional Patient Remote Key Functions	44
Optional Patient Remote
Key Functions - FM Radio	45
Patient Parental Control Menu	46 - 47
Patient Menus and On-Screen Displays	48
Maintenance	49
Troubleshooting	50
Glossary	51
Warranty for HealthView Series TVs	Back
	Cover

Optional Installer and Patient Remote Controls:

Shown herein are optional remote controls that can be used by the installer and the patient. Be advise that these remote controls are NOT included with this TV. However, these remotes can be purchased separately, see your Zenith Electronics dealer.

Installer/Hospital Note:

Pages 44, 45, 46, 47 and 48 contain information and menus which the patient can use to operate the TV. It is recommended that these four pages be copied and included with the literature packet that the hospital provides to the patient.

Purchase the Optional Installer’s Remote and Clone Programmer

To perform a normal installation set up, you need an installer’s remote such as the HP602, and the LT2000 Quickset II Clone Programmer—both are shown and described in later sections. The installer remote allows access to the Installer menus, User menus, and Source/Channel Bank keys. The installer remote has Menu, Select, and Adjust, and Channel Bank Keys. The LT2000 Quickset II Clone Programmer is used to duplicate a TV’s setup and install it on another identical TV.

See your Zenith Dealer.

Design and specifications subject to change without prior notice.

Page 5