Zenith DTV1080 warranty Zenith Electronics Corporation

Page 102

206-3675

ZENITH ELECTRONICS CORPORATION

HD SATELLITE RECEIVER LIMITED WARRANTY-USA

Zenith, will repair or replace your product, at Zenith’s option, if it proves to be defective in material or workmanship under nor- mal use, during the warranty period listed below from the date of original consumer purchase. This warranty is available only to the original purchaser of the product and effective only when used in the United States, excluding U.S. Territories.

ONE YEAR WARRANTY PERIOD:

HOW SERVICE IS HANDLED:

0 to 90 days: Your unit will be repaired or replaced

If replacement unit is available and to get the unit in 2

with a new, substitute model or factory reconditioned

working days, Zenith requires a reserved deposit by credit

unit. If repaired, parts may be new or remanufactured.

card as surety for advance shipment. Your credit card will

91 to 365 days: Your unit will be repaired or replaced

not be charged if you returned the defective unit in 10 working

days. For further instructions please see below.

with a new, substitute model or factory reconditioned

 

unit. Zenith may add a fee for labor charges. If

Please retain your box to return the unit to Zenith.

repaired, parts may be new or remanufactured.

Shipping charges both ways for claims within the first

 

Repair Parts and Replacement Units are warrant-

90 days will be paid by Zenith; after 90 days during the

ed for the remaining period of the original warranty.

warranty period, you pay in-bound shipping charges

 

and Zenith pays return shipping charges.

 

 

THIS WARRANTY IS IN LIEU OF ANY OTHER WARRANTY,

EXPRESS OR IMPLIED, INCLUDING WITHOUT LIMITATION, ANY WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. TO THE EXTENT ANY IMPLIED WARRANTY IS REQUIRED BY LAW, IT IS LIMITED IN DURATION TO THE EXPRESS WARRANTY PERIOD ABOVE. ZENITH WILL NOT BE LIABLE FOR ANY INCIDENTAL, CONSEQUENTIAL, INDIRECT, OR SPECIAL DAMAGES OF ANY NATURE, INCLUDING WITHOUT LIMITATION LOST PROFITS PROGRAMMING OR DATA, OR ANY OTHER DAMAGE WHETHER BASED IN CONTRACT, TORT OR OTHERWISE. Some states do not allow the exclusion or limitation of incidental or consequential damages or limitations on how long an implied warranty lasts, so the above exclusion or limitation may not apply to you. This warranty gives you specific legal rights and you may also have other rights that vary from state to state.

THIS LIMITED WARRANTY DOES NOT APPLY:

To damages or problems that result from shipping, installation, calibration, maintenance or separate system components.

To damages or problems that result from misuse, abuse, operation outside environmental specifications or contrary to the requirements and precautions in the Operating Guide, accident, lightening strikes or other natural causes, modification or alter- ation, incorrect electrical current or voltage, signal reception or input, software errors that do not disable functionality, operat- ing and software protocols adopted after date of manufacture or for outside the U.S., or institutional or commercial use.

Therefore, you pay for the cost of repair or replacement under these circumstances.

CUSTOMER ASSISTANCE NUMBERS:

To prove warranty coverage:

Retain your dated sales receipt to prove date of purchase as well as

 

your box for shipping the unit in to Zenith.

 

Legible copy of your sales receipt must be submitted with the unit

 

at the time warranty service is provided.

 

 

To obtain where-to-buy, product assis-

Call 1-877-9Zenith 1-877-993-6484 (Mon. - Fri. 7AM to 8 PM CT)

tance customer assistance or Return

Sat 8AM to 5PM. Please select the appropriate option from the menu.

Authorization:

 

 

 

FOR SERVICE:

You must call Product Assistance (1-877-984-9349 Mon. - Fri. 7AM to 8PM CT Please select the appropriate option

from the menu), to confirm the product is defective and to obtain Return Authorization (RA). If requesting 2-day advance shipment they will ask for your credit card number. During the warranty period, Zenith will send you a return-shipping label. After you obtain authorization for return, please box your unit with a copy of the sales receipt and enough packing material to assure undamaged delivery of your product. When you receive the label, place it on the box and call the 800 # in the instruction for pick-up. When your unit is received, Zenith will repair or replace your unit in accordance with this Limited Warranty. For advance shipment, the return label will come with

The replacement sent to you. Please follow boxing and shipping instructions above.

101

Image 102
Contents Warranty High Definition HD Satellite ReceiverDo not Open Important Safety Instructions Power-Cord Protection Outdoor Antenna GroundingLightning Replacement Parts Power LinesDamage Requiring Service Safety CheckImportant Information Table of Contents EZ Help Reference Introduction New World of Digital EntertainmentMain Features Sending Signals Important OverviewTV Signal Formats Signal Format Analog NtscCropped Normal and Wide Format SignalsLetter box SqueezedPanorama NormalWide Zoom1Audio Signals Digital Audio SignalsAnalog Audio Signals On-Screen Display Main MenuEZ Help Setup and Connections Remote Control Cables 6 itemsReceiver Unpacking Back Panel of the Zenith HD Satellite Receiver Back Panel of the Zenith HD Satellite Receiver General Recommendations Connection ComponentConnecting to Antennas No Dish Receiving SignalsConnecting to Antennas Round Dish Satellite a Connecting to Antennas Oval Dish Satellite A, B Connecting to Antennas Oval Dish Satellite A, B, C TV Connection Analog TV TV ViewingTV Connection HD Monitor Y/PB/PR type TV Connection HD Monitor RGB type Refer to .5, ‘Connecting to TV’ VCR ConnectionVCR Recording Audio Connection Digital Audio System Dolby AC-3 ConnectionAudio connection Analog Hi-Fi System Hi-Fi System ConnectionUsing the Front Panel of the HD satellite receiver Digit Buttons 0~9 Using the Remote ControlMode DashVol + SignalMute CH +Help ? SurfInfo Thumbstick Menu directional arrowsProgramming the Remote Control Test your remote controlRemote Control Codes for Other Components TV CodesVCR Codes DVD CodesAUX Audio Initial Setup Rating Basic OperationViewing the Channel Banner CategoryAlternate Audio Input Source IconLock Icon Mail IconChannel Surfing 206-3675 About the Advanced Program Guide Press the Guide button on your remote controlAdvanced Program GUIDE To bring up the APGCustom Layout of the Advanced Program Guide ScreenAll Surf Movies SportsScrolling Moving through the Advanced Program GuideLine Scrolling Date ScrollingFuture / Free-of-charge Selecting a ProgramCurrent / Free-of-Charge Current / Pay Per ViewGetting More Information To display program detailsReferring to EZ Help Making a Remind List for Future Viewing To schedule a future viewingPurchasing Pay Per View Programs To purchase PPV programsSearching Programs by Category To search programs by CategorySearching Programs by Keyword To search programs by keywordTo bring up and exit the Menu CustomizationStructure of the On-screen Menus To go to the next levelDigital Output Audio Mode Audio Variable Audio Language AudioTo cancel a program in the Remind List Previewing the Remind ListTo cancel a newly purchased program Managing Program PurchasesNew Purchase Purchase List To review programs in the Purchase ListChecking the Mail Box To check the Mail BoxSelect Dish About Initial SetupInitializing the System To select dishYour Location To enter your locationSignal Strength To see the signal strengthChannel Setup To scan the channels from the satellitesRepeat from 6 to Managing Channels EZ Channel Scan Channel SearchTo scan the channels with the antenna Manual Ch. Add To add the channels missed in your channel listEdit Channel To create a custom listManaging Channels EZ Hook Up To see EZ Hook-upSetting the Clock Clock AutoTo set auto clock Clock Manual To set manual clockSetting the Audio Setting Digital OutputTo set the digital audio mode PCMDigital Dolby DigitalAudio Mode To Set the Analog Audio ModeAudio Language To set the digital audio languageVariable Audio To set Variable AudioChoosing the Aspect Ratio Choosing the screen format of your TVLetter Box Setting Closed Caption To set Closed CaptionCaption3 CC3 Caption1 CC1Caption2 CC2 Caption4 CC4Setting Default Signal Out Output ChannelTo set the channel number of the HD satellite receiver Out to TV -- Default Connection To set the standby mode default signal sourceSetting the Digital TV Input To set the standby mode as a default signal sourceDigital TV Input Running EZ Demo To run EZ DemoSetting Locks Lock SystemTo activate or deactivate the Lock System Block Channel To block channelsMovie Rating To block movie programsTV Rating for Children’s Programs To block TV programsTV-MAMature Audience Only TV Rating for General Programs Spending Limit To set the spending limit of each PPV programTesting the System To test the HD satellite receiverTo upgrade the software in your Zenith HD Satellite Receiver Upgrading SoftwareReplace Card To replace the cardEZ Help EZ HelpSimply press and hold to see the helpful information See the EZ Help feature Product Specifications InputAudio Features Troubleshooting Check if a mode on the remote control is selected properly Make sure the batteries are fresh and installed properlyPoint the remote control unit at the remote control sensor Them to clear your passwordZenith Electronics Corporation 6owz7 oenwnw No 3828VA0220B ND00QA, SH-011S