Radio Shack 61-2677C owner manual Connecting Lights or Appliances to Modules

Page 13

61-2677CD.fm Page 13 Tuesday, July 6, 1999 11:05 AM

CONNECTING LIGHTS OR

APPLIANCES TO MODULES

Caution: Before you con- nect any light or appliance to a module, press ALL UNITS OFF. This assures that all of the modules are powered off.

Set the power switch on the light or appliance to the on posi- tion, then plug the light or appliance directly into the plug’s power module. Plug the module into a wall outlet, if neces- sary.

Write down your unit codes, module locations, and connect- ed devices on the supplied chart. (See “Plug ’N Power Sys- tem Chart” on Page 24.)

See “Operation” on Page 14 to test each module. See “Troubleshooting” on Page 22 if your system does not work properly.

13

Image 13
Contents Mini Remote Control Center Introduction Contents Preparation On the controller and all the modules it House CodesUnit Codes Setting UP the Control Center InstallationSetting UP the Modules 61-2677CD.fm Page 8 Tuesday, July 6, 1999 1105 AM Command 61-2677CD.fm Page 10 Tuesday, July 6, 1999 1105 AM 61-2677CD.fm Page 11 Tuesday, July 6, 1999 1105 AM Setting the MODULE’S Codes Connecting Lights or Appliances to Modules Controlling Modules by Unit Codes OperationTurning on ALL Lights Turning OFF ALL Units Dimming Lights Manual Control of Lights and Appliances Intercom Interference Power InterruptionsSafety Precautions 61-2677CD.fm Page 21 Tuesday, July 6, 1999 1105 AM Problem Remedies Troubleshooting61-2677CD.fm Page 23 Tuesday, July 6, 1999 1105 AM Plug ’N Power System Chart Care 61-2677CD.fm Page 26 Tuesday, July 6, 1999 1105 AM 61-2677CD.fm Page 27 Tuesday, July 6, 1999 1105 AM 07A99